Komatsu — CHECK AND ADJUST RUBBER SHOE TENSION (MACHINE EQUIPPED WITH RUBBER SHOES)

. MAINTENANCE MAINTENANCE PROCEDURE Increasing Track Tension NOTICE Loosening Track Tension WARNING given below. If is not 4 - 33 The standard value is low, so be care ful not to tighten the rubber sh oe too Prepare a g rease pump. 1. 2. 3. 4. 1. Pump i n grease through grea se fitting (2) with a grease p ump. 2. To che ck that the correct ten sion has been achieved, ru n the engine at low idle, move the m achine slowly forwards (7 t o 8 m (23.0 to 26.3 ft)), then stop th e machine. 3. Check the rubber shoe tensio n again, and if the tension is not correct, adjust it again. 4.

If the te nsion is still low after s upplied grease, the rubber shoe needs t o be replaced or the seal in the cylinder needs to be replace d. Ask your Komatsu distributor for replacement. It is extreme ly dangerous to release the grease by any method ex relieved by t his procedure, please co ntact your Komatsu distributor the proced the track te nsion i 1. Loosen plug (1) gradually to r elease the grease. it a maximum of one turn. 2. When l oosening plug (1), turn it a maximum of one turn. 3. If the gr ease does not come o ut smoothly, move the ma chine forward s and backwards a sh ort distance. 4. Tighten plug (1). 5.

To che ck that the correct ten sion has been achieved, ru n the engine at low idle, move the m achine slowly forwards (7 t o 8 m (23.0 to 26.3 ft)), then stop th e machine. 6. Check the rubber shoe tensio n again, and if the tension is not correct, adjust it again. 7. Check t he track tension again , and if the tension is not co rrect, adjust i t again.