Komatsu — REPLACE RUBBER SHOES (MACHINE EQUIPPED WITH RUBBER SHOES)

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE RUBBER SHOES (Machine equipped with rubber shoes) WARNING ground, then stop the machine. Prepare a grease gun Prepare a steel pipe Rubber Shoes Removal WARNING 4 - 34 Carry out this ope ration with two workers. Th e operato r must m ove the dance with the signals from the other worker. The rubber shoe s are replaced with the machine raised, ous if the machine is lower ed by mistake du ring the ation. During the replaceme nt operation, nev er move rack except the rubber shoe track to be repla go under or put any part of y our body under th e rubber e during the replacement o peration.

To check that the track tension is correct, ru n the engine at l ow idle, e forward a distance equal rack on NOTICE It is possible to chan ge from the rubber shoe to the road l iner and steel shoe. Howeve r, it is necessary to r emove the idle r guard and to carry out adju stment, so always contact your Komatsu dis tributor to have the replacemen t carried out. It is extremely da ngerous to release the greas e by any method except the procedu re given below. If the rubber shoe tension is not relieved by t his procedure, ple ase contac t your Ko matsu distributor fo Check that all the grease has been released b efore rotating the sprocket t o remove the rubber shoe. 1.

Raise the cha ssis with the boom and a is, operate the levers slo