. MAINTENANCE MAINTENANCE PROCEDURE 4 - 43 3. Bleedin g air from NOTICE If the engine i s run at hi gh speed immed iately after startup or a cylinder i s pushed u p to its stroke e nd, air take n inside the cylinder may cause da mage to t he piston packi 1) Run the eng ine at low idle, and exte nd and re tract each cylinder 4 to 5 times, t aking care that a cylinder is not moved to the end of its stroke. ( Stop the c ylinder ap prox. 100 mm ( 3.9 in) short of its stroke end) 2) Nex t, operat e each cylinde r 3 to 4 ti mes to th e end of it s stroke. 3) Finally, oper ate each cylind er 4 to 5 times to t he end of its stroke to co mpletel y remove t he air. 4.
Bleedin g air from attachment ( NOTICE If the method of ble eding the air fro m the attachment its elf is speci fied by the manufacturer , bleed the air according to the specified p rocedure After completing the air bleeding op eration, st op the eng ine, and lea ve the machine f or 5 minutes before starting operations. This will re move the air bubbles in t he oil insid e the hydr aulic cylind Chec k that there is no leakage of oil and wipe off any oil that has be en spilled. f a breaker or ot her attachment has bee n installed , run the e ngine at l ow idl e and o perate the attachment pedal epeatedly (appr ox. 10 times) u ntil the a ir has bee n bled fro m the attachme nt circu