. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. PC35MR 7.2 liters (1.9 US gal) 1. Remove the cover under the machine, then set a container under drain plug (P) to catch the oil. REMARK There is no undercover installed on the PC27MR. REMARK 4 - 48 Engine oil pan capacity: Prepare a filter wrench Change the oil and replace the cartridge once every 6 months, hours.
In the same way, change th e oil and replace the cartridge once every 500 hours, even if th e engine has not been operated for 6 months. 2. Remove drain plug (P) and drain the oil. 3. Check the drained oil particles or foreign ma distributor. 4. Install drain plug (P). 5. Install the undercover. slowly to avoid getting oil on yourself, , and if there are excessive metal terial, please contact your Komatsu over. 6. Open the engine rear c 7. Using a filter wrench, tu rn filter cartridge (1) counterclockwise to remove it. 8. Clean the filter holder, c oat the new filter cartridge packin g and threaded portion with cle install.
an oil (or coat thinly with grease), then Check that there is no old p is any old packing stuck to t acking stuck to the filter holder. If he filter, it will cause leakage of there oil. 9. When installing; tighten until the packing surface contact s the seal surface of the filter h older, then tighten it up 1/2 to 3/4 of a turn. 10. After replacing the filter cartridge, add oil through oil filler (F) until the oil level is between the H and L marks on the dipstick (G). 11. Run the engine idle for a while, then stop the engine and confirm that the oil level is bet ween the H and L lines according to "Check Oil Level in Engine Oil Pan, Add Oil (PAGE 3-43)".