Komatsu — CHECK AND ADJUST COOLING FAN BELT TENSION

. MAINTENANCE MAINTENANCE PROCEDURE CHECK AND ADJUST COOLING FAN BELT TENSION Checking 1. The deflection should be approx. 9 to 13 mm (0.355 to 0.5 in) when pressed at a point midway between the crankshaft pulley and the fan pulley with a finger pressure of approx. 98 N (10 kgf). REMARK guideline, there is no problem if the deflection is approx. 10 Adjustment WARNING Prepare a pinch bar. Prepare a wooden block. 4 - 53 As a mm When this maintenance is carried out, it is necessary to open (tilt) the floor.

Before starting the operation to open the floor, read the precautions in "CAUTION S FOR OPENING (TILTING) FLOOR (PAGE 2-34)" in the safety and maintenance sections thoroughly, and refer to the explanat ion for each part in "METHOD OF OPENING (TILTING) FLOOR (PAGE 3-31)" when carrying out the operation. Or ask yo maintenance. Immediately after the engine is stopped, the parts and oil are at a high temper temperature to go down before starting the operation. ur Komatsu distributor to carry out the ature, and will cause burns. Wait for the 1. When opening (tilting) the floor, see "When Opening (tilt open) (PAGE 3 -31)" for details. 2.

Insert a bar between alternator (1) and the cylinder block to fix alternator (1) in position. When fixing alternator (1) in position, insert a wooden block between the bar and alternator (1) to prevent any damage to the alternator. Loosen alternator adjustment bolt (2) and mounting bolts (3). Move alternator (1) to adjust so that the belt tension is approx. 7 to 10 mm (0.276 to 0.4 in) when pressed at a point midway between the alternator pulley and the fan pulley with a finger pressure of approx. 98 N (10 kgf). 3. 4. 5. Tighten adjustment bolt (2), then tighten mounting bolts (3) to secure alt ernator (1) in position. 6. Check for damage to the pulleys, and wear of the V-groove and V-belt.

B e particularly careful to check that the V-belt is not in contact with the bottom of the V-groove. If the belt is stretched, leaving no allowance for adjustment, or if it is distributor for replacement. cut or cracked, contact your Komatsu Closing (tilt close) (PAGE 3-34)". 7. 8. After completing the adjustment, close the floor. For details, see "When