. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING cause burns. Wait for the the lock, see "In Case of Engine Rear Cover and Dirt Cover (PAGE 3-28)") 2. Remove grease gun (9), then remove bolt (12) and take off grease gun holder (10). the internal 4 - 54 EVERY 1000 HOURS MAINTENANCE Carry out the mai ntenance for EVERY 500 HOUR The parts and o il are at high temperature immedia tely after the engine is stopped, and may ase the internal pressure, then remove it. temperature to g o down before starting the work.
When removing t he oil filler cap, tur n it slowly to rele NOTICE uipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket f the machine is eq operations. For d maintenance. etails, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-16)" when carrying out 1. Open dust co ver (1) fully until i t is secured in p the method of opening and closin 3. Remove bolt (13), then remove divider plate (1 4. Loosen bolt ( 2), then remove p late (3) to the fr 5. Remove the pressure. cap from oil filler (F), and relea 6. Remove bolts (4), then remove cover (5). Wh the cover may cover pushed fly off under the force of spring down when removing the bolts.
7. After removin g spring (6) and v alve (7), take o 8. Clean the rem pved parts in diesel oil. 9. Install the new element where old element (8) was installed. Inspect the O -ring set between the hydraulic ta nk and cover (5). If there are any scrat ches, replace the O-ring. 10. Set valve (7) and spring (6) on top of the elem ent. , and tighten cover mounting bolts (4) to install cover (5). 11. Set cover (5) in position, hold i t down by hand , and tighten cover mounting bolts (4) to