Komatsu — CHECK ENGINE VALVE CLEARANCE, ADJUST

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE CHANGE OIL IN FINAL DRIVE CASE WARNING removing and adjusting the parts, you should request service from your Komatsu 4 - 55 12. Exten d the boom, arm, and buc ket cylinder fully as shown in the dia gram on the right, remov e the oil filler cap, then install e of the tank. the ca p and pressurize the insid Be s ure to p ressurize the hydraulic tank. If it is not pressurized, the pump will suck in air, and this will adversely af 13. Install divider plate (11) with bol 14. Install grease gun holder (10) w ith bolt (12), then install greas e gun 15.

Close cover (1) at right side of t T he part s and oil are at high temperat ure immediately after the engine i s stopped, and ma y cause seriou s burns. Wait f or the t emperat ure to go down before starti ng the operation. ide the case, the oil or plug may fly out. pressure. I f there i s still pressure remaining ins ide the case, the oil or plug may fl L oosen t he plug slowly to release the P repare a container to catch drai P repare a hexagon wrench. 1. Set so p, with plug (G) and plug (P) der plug (P). (P) 2. Set th e container to catch oil un 3. Using a hexagon wrench, remov e plugs (P) and (G), and drain the oil . n plug (P). 4. Tighte 5.

Add th e replacement amount of oil through the hole of plug (G). 6. When oil comes out from the ho le of plug (G), install plug (G). CHECK ENGINE VALVE CLEAR As specia l tools is required for rem . distributor