Komatsu — HYDRAULIC CIRCUIT

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT HYDRAULIC CIRCUIT Hydraulic Circuit Connection 2 ), so check the 6 - 14 NOTICE The pressure for the hydra ulic equipment for t he attachments used on th is machine is se t at 17.2 MPa ( pressur e resistance of the attachment Installe When c onnecting the a ttachment, conne ct the h ydraulic circuit as follows. ck . 1. Lock the attachment control pedal with the attachment lo cover. 2. Remove the cap of the quick coupler. Be careful not to damage or lose the parts that are removed 1. Loc k the cover. 2. Remove the cap of the quick couple Be careful not to da mage or lose the parts t hat are removed 3.

Connect the piping (quick coupler) s upplied by the attachm ent manufactu The following prod ucts are used for t he quic k coupler. Arm left side (hole end): STUCCHI ( F FIRG12A BSP) Arm right side (sha ft end): PC27MR STUCCHI (APM13 1/2 BSP) PC35MR STUCCHI (APM15 3/4 BSP) The size of the qui ck coupler mounti ng screws for the elbow installed to t he block is a Lef t side of arm (ho le side): G1/2 MR G1/2 MR G3/4 Right side of arm ( shaft side): PC27 MR G1/ PC35 MR G3/ REMAR If the q uick coupler siz e does not match, please contact your K omatsu NOTICE When co nnecting the pipi ng, operate the buck et fully t o th e dump positi and be c areful not to inter fere with link (a).