Transmissions Eaton ® Fuller ® Straight-Shift Models Upshifting 1. Position the gear shift lever in neutral, then start the engine. Bring the air system pressure up to 100 to 120 psi (689 to 827 kPa). Refer to the Eaton website for additional information, www.roadranger.com. General Information, Eaton Straight- Shift 2. Depress the clutch pedal to the floor. Shift into 1st gear, then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. Accelerate to engine governed speed. Eaton Fuller straight-shift model transmissions are not synchronized. They have seven forward speeds and one reverse speed. See Fig. 8.1 for the shift pattern.
They are designed for use with on-highway, fuel economy engines, where a minimum of shifting is desired and less gear reduction is acceptable. 3. Once governed speed has been reached, disen- gage the clutch, and shift the lever to neutral. Engage the clutch; allow the engine speed to drop about 800 rpm (the rpm drop may vary with engines of different governed speeds), then dis- engage the clutch. Move the shift lever to 2nd gear, then engage the clutch, and accelerate to engine governed speed. R 2 4 6 Continue shifting upward, from 2nd to 3rd gear, 3rd to 4th gear, and 4th to 5th gear, using the same sequence. See Fig. 8.1 for the shift pat- tern. N 4.
Again, at governed speed, disengage the clutch, and shift into neutral. Engage the clutch; allow the engine speed to drop about 500 rpm (rpm drop may vary with engines of different governed speeds), then disengage the clutch. Move the shift lever to 6th gear, then engage the clutch, and accelerate to engine governed speed. 1 3 5 7 03/13/96 f260055a Fig. 8.1, Eaton Fuller Straight-Shift Model Transmissions Shift Pattern Operation, Eaton Straight-Shift Downshifting Shift into 7th gear, using the same sequence. 1. Always use 1st gear when starting to move the vehicle forward. When downshifting, shift down from 7th gear through each lower gear, as follows: 2.
Use the clutch brake to stop gear rotation when shifting into 1st or reverse when the vehicle is stationary. The clutch brake is actuated by de- pressing the clutch pedal all the way to the floor. 1. Allow the engine speed to drop about 500 rpm (rpm drop may vary with engines of different gov- erned speeds) below the governed speed. De- press the clutch pedal enough to release the torque, then shift into neutral. Engage the clutch and bring the engine rpm up to governed speed. Disengage the clutch, shift into gear, and engage the clutch smoothly. For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. 3.
Use double-clutching between all upshifts and downshifts. 4. After your shifting ability improves, you may want to skip some of the ratios. This may be done only when operating conditions permit, depend- ing on the load, grade, and road speed. Follow the same sequence to downshift from 6th into 5th gear. 2. When in 5th gear, and ready for the next down- shift, allow the engine speed to drop about 800 rpm (rpm drop may vary with engines of different governed speeds) below the governed speed. Depress the clutch pedal enough to release the IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle. 8.1