Transmissions torque, then shift into neutral. Engage the clutch and bring the engine rpm up to governed speed. Disengage the clutch, shift into 4th gear, and en- gage the clutch smoothly. See Fig. 8.2 for the shift patterns, noting that the 3rd/7th and 4th/8th shift positions in the RT (direct ratio) and RTX-B (overdrive ratio) transmissions are opposite of the RTO (overdrive ratio) transmissions. The RTX-P ratio transmissions have the 1st/5th shift positions where LO is in the A and B ratio transmis- sions. The top gear in the RTX-P ratio transmissions is called 9th gear. Follow the same sequence to downshift from 4th into 3rd, 3rd into 2nd, and from 2nd into 1st gear. IMPORTANT:
Never use the clutch brake when downshifting, or as a brake to slow the vehicle. Eaton Fuller Range-Shift Models 10-Speed RT, RTO, and RTX Models Eaton Fuller 10-speed range-shift model transmis- sions have ten selective, evenly-spaced forward ra- tios. Each transmission consists of a 5-speed front section, and a 2-speed rear range section. The ten forward speeds are obtained by twice using a 5-speed shift pattern: the first time in low range, the second time in high range. See Fig.
8.3 for the shift patterns, noting that the 4th/9th and the 5th/10th shift positions in the RT (direct ratio) and RTX (overdrive ratio) transmissions are directly opposite in the RTO (overdrive ratio) transmissions. Refer to the Eaton website for additional information, www.roadranger.com. General Information, Eaton Range- Shift Range-Shift transmissions are typically upshifted by moving the shift lever through all of the low gear po- sitions and then activating a range switch to provide an additional set of ratios in the high range using the same shift lever positions as used in low range.
The shift lever then is moved sequentially through each position as before but all the positions now provide a higher gear ratio. The initial low gear is often used only in low range. Operation, Eaton Range-Shift 1. When operating off-highway, or under adverse conditions, always use low gear (if so equipped) when starting to move the vehicle. When operating on-highway, with no load, or under ideal conditions, use 1st gear when start- ing to move the vehicle (except when equipped with a 9-speed RTO transmission, then always start in low gear).
Eaton Fuller Range-Shift transmissions are not syn- chronized in the front section, but the range section is synchronized to prevent grinding gears during range shifts. For all conditions, use the highest gear that is still low enough to start the vehicle moving with engine idling, and without slipping the clutch ex- cessively. IMPORTANT: Not all lever positions are used in each range and the shift patterns vary between transmissions. Be sure to read the shift pattern decal on the dash for the operating instructions for the specific transmission installed in your vehicle. 2. Use the clutch brake to stop gear rotation when shifting into low (or 1st) or reverse when the ve- hicle is stationary.
The clutch brake is actuated by depressing the clutch pedal all the way to the floor. 9-Speed RT, RTO, and RTX Models Eaton Fuller 9-speed range-shift model transmissions have a 5-speed front section, and a 2-speed rear range section. The low gear in the front sections of the RT-8609 and A and B ratio transmissions is used only as a starting ratio. The high gear in the front section of the "P" ratio transmissions is used only as the top gear. The remaining gear positions of the above transmissions are used once in the low range and once in the high range. For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. 3.
Do not make range shifts with the vehicle moving in reverse gear. 4. Never attempt to move the range preselection lever with the gear shift lever in neutral while the vehicle is moving. Preselection with the range 8.2