Freightliner FLD Conventional — FLD Conventional

Transmissions A B C 5 7 3 1 4 5 8 8 6 2 1 4 N N N D 2 8 6 4 E 6 7 3 2 9 1 5 7 3 03/13/96 f260027a A. All RT and RTX-B Transmissions B. All RTO Transmissions C. All RTX-P Transmissions D. Up for High Range E. Down for Low Range Fig. 8.2, Eaton Fuller 9-Speed Range-Shift Transmissions Shift Patterns A B 2. Position the range preselection lever down, into low range. Lo R Hi R Hi 7 2 9 4 Lo 7 2 10 5 3. Depress the clutch pedal to the floor. Shift into low or 1st gear ( Table 8.1 ), then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. Accelerate to 80 per- cent of engine governed speed. N C N 6 1 8 3 10 5 D 6 1 8 3 9 4 4.

Shift progressively upward from low or 1st gear, to the top gear in low range ( Table 8.1 ), double- clutching between shifts, and accelerating to 80 percent of engine governed speed. 03/13/96 f260043a A. All RT and RTX Transmissions B. All RTO Transmissions C. Up for High Range D. Down for Low Range CAUTION Fig. 8.3, Eaton Fuller 10-Speed Range-Shift Model Transmissions Shift Patterns To prevent damage to the range section syn- chros, make sure the range preselection lever is in high range before moving the shift lever to neutral. Leave the shift lever in neutral long enough to be sure the range section has shifted.

preselection lever must be made prior to moving the shift lever out of gear into neutral. 5. Do not shift from high range to low range at high vehicle speeds. 5. While in the top gear of the low-range shift pat- tern, and ready for the next upshift, flip the range preselection lever up into high range. With the lever in high range, double-clutch through neu- tral, and shift into the bottom gear of the high range ( Table 8.1 ). As the shift lever passes through neutral, the transmission will automati- cally shift from low range to high range. 6. Use double-clutching between all upshifts and downshifts. 7. After your shifting ability improves, you may want to skip some of the ratios.

This may be done only when operating conditions permit, depend- ing on the load, grade, and road speed. Upshifting 1. Position the gear shift lever in neutral. Start the engine, and bring the air system pressure up to 100 to 120 psi (689 to 827 kPa). 8.3