Transmissions Eaton Fuller Shift Progressions through neutral, and shift into the top gear of the low range. As the shift lever passes through neu- tral, the transmission will automatically shift from high range to low range. TRANS. MODEL LOW RANGE HIGH RANGE Off-Highway On-Highway 9-Speed Direct or Overdrive (RT or RTX) R R R 5 7 3. With the transmission in low range, downshift through the low range gears as conditions re- quire. 1 3 1 3 6 8 LOW 2 f260322 4 2 f260323 4 f260324 IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle.
9-Speed Direct (RTX-P) R 2 4 R 2 4 R 6 8 1 3 1 3 5 7 9 Eaton Fuller Splitter and Range-Shift Models R f260325 R f260325 R 5 f260326 8 9-Speed Overdrive (RTO) 1 4 1 4 6 7 Refer to the Eaton website for additional information, www.roadranger.com. 3 LOW 2 f260327 3 LOW 2 f260327 f260328 10-Speed Direct or Overdrive (RT or RTX) R 2 4 R 2 4 R 7 9 General Information, Eaton Splitter and Range-Shift 1 3 5 1 3 5 6 8 10 Combination splitter and range-shift transmissions allow the choice of two splitter ratios in each lever position as well as the additional ratios provided in each lever position after shifting to the other range.
R f260329 R f260329 7 f260330 10 10-Speed Overdrive (RTO) 2 5 2 5 R 6 8 9 1 3 f260331 4 1 3 f260331 4 f260332 IMPORTANT: Not all lever positions are used in each range and the shift patterns vary between transmissions. Be sure to read the shift pattern decal on the dash for the operating instructions for the specific transmission installed in your vehicle. Table 8.1, Eaton Fuller Shift Progressions 6. With the transmission in high range, shift pro- gressively upward through each of the high range gears ( Table 8.1 ), double-clutching be- tween shifts. 13-Speed RTO Models Downshifting Eaton Fuller 13-speed RTO model transmissions have thirteen forward speeds and two reverse speeds.
Each transmission consists of a 5-speed front section, and a 3-speed auxiliary section. The auxiliary section contains low- and high-range ratios, plus, an overdrive splitter gear. See Fig. 8.4 for the shift patterns. 1. With the transmission in high range, shift pro- gressively downward to the bottom gear in high range, double-clutching between shifts. CAUTION To prevent damage to the range section syn- chros, make sure the range preselection lever is in low range before moving the shift lever to neu- tral. Leave the shift lever in neutral long enough to be sure the range section has shifted. All of the thirteen speeds are controlled with one shift lever.
Built into the shift knob of the lever, are a range preselection lever and a splitter control button (on the side of the shift knob), that control range se- lection and gear splits, respectively. 2. When in the bottom gear of the high-range shift pattern, and ready for the next downshift, push the range preselection lever down into low range. With the lever in low range, double-clutch Low gear in the front section is used only as a start- ing ratio. The remaining four forward positions are used once in the low range and once in the high range. However, each of the four high range gear positions can be split with the underdrive ratio (RT 8.4