Transmissions models), or overdrive ratio (RTO models) of the split- ter gear. Ratios cannot be split while the transmis- sion is in low range. lever is down (in low range). When in high range and the splitter control button is in the forward position, the range preselection lever cannot be moved down. 1 Lo Hi R 1 3 Dir OD 5 5 Dir OD 7 7 1. When operating off-road, or under adverse condi- tions, always use low gear when starting to move the vehicle forward. A N When operating on-highway, with no load, or under ideal conditions, use 1st gear when start- ing to move the vehicle forward.
6 6 8 8 B For all conditions, use the highest gear that is still low enough to start the vehicle moving with the engine at or near idle speed, and without slipping the clutch excessively. 2 4 LOW Dir OD Dir OD C D 03/13/96 f260044a A. Up for High Range B. Down for Low Range C. Forward for Overdrive D. Rearward for Direct 1. Splitter Control Button 2. Use the clutch brake to stop gear rotation when shifting into low (or 1st) or reverse when the ve- hicle is stationary. The clutch brake is actuated by depressing the clutch pedal all the way to the floor. Fig.
8.4, Eaton Fuller 13-Speed RTO Model Transmissions Shift Patterns 18-Speed RTLO Models For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. Eaton Fuller 18-speed RTLO model transmissions have eighteen forward speeds and four reverse, con- sisting of a 5-speed front section and a 3-speed aux- iliary section. The auxiliary section contains low and high range ratios, plus an overdrive splitter gear. 3. Use double-clutching between all upshifts and downshifts that require movement of the shift lever. Splitting of the high range gears does not require movement of the shift lever.
One ratio in the front section (low) is used as a start- ing ratio; it is never used when the transmission is in high range. 4. Never move the shift lever into low gear while in high range. The other four ratios in the front section are used once in low range and once again in high range; however, each of the five ratios (low–1–2-–3–4) in low range and each of the four ratios in high range can be split with the overdrive splitter gear. 5. Never move the splitter control button while in neutral. 6. Do not preselect with the splitter control button. After moving the control button, complete the shift immediately. All of the eighteen speeds are controlled with one shift lever.
Built into the shift knob of the lever, are a range preselection lever and a splitter control button (on the side of the shift knob), that control range se- lection and gear splits, respectively. 7. Except when downshifting from 5th direct to 4th gear, never push the range preselection lever down into low range while operating in high range-the splitter will become inoperative. Operation, Eaton Splitter and Range- Shift 8. Do not shift from high range to low range at high vehicle speeds. 9. Do not make range shifts with the vehicle moving in reverse gear. IMPORTANT:
On 13-speed transmissions, the shifter knob has an interlock feature that pre- vents the splitter control button from being moved forward when the range preselection 10. Never attempt to move the range preselection lever with the gear shift lever in neutral while the vehicle is moving. Preselection with the range 8.5