Transmissions 13-Speed Models Reverse Meritor 13-speed transmissions have thirteen forward speeds and two reverse speeds. Each transmission consists of a 5-speed front section, and a 3-speed auxiliary section. The auxiliary section contains low- and high-range ratios, plus, an overdrive splitter gear. See Fig. 8.18 . To drive in reverse, push the range selector lever down to put the transmission in the low range. Push the clutch pedal to the bottom of travel so the clutch brake slows the transmission for initial gear engage- ment. Holding the clutch pedal at the bottom of travel, shift into reverse. Slowly release the clutch pedal to move the vehicle in reverse.
Hi R 1 3 Dir OD 5 5 Dir OD 7 7 1 Lo A Upshifting N 1. To drive forward, make sure the vehicle is com- pletely stopped and the range selector lever is pushed down to put the transmission in the low range. B C 2 4 LOW Dir OD Dir OD 6 6 8 8 D Push the clutch pedal to the bottom of travel so the clutch brake slows the transmission for initial gear engagement. Holding the clutch pedal at the bottom of travel, shift into low. 03/13/96 f260154a A. Up for High Range B. Down for Low Range C. Up for Overdrive D. Down for Direct 1. Splitter Control Button 2. Slowly release the clutch pedal to begin moving the vehicle forward. Fig. 8.18, Meritor 13-Speed Transmission Shift Pattern 3.
To upshift into 1st gear, only partial depression of the clutch pedal is needed. Do not push the clutch pedal all the way to the floor and engage the clutch brake; instead, partially depress the clutch pedal, and move the shift lever into neu- tral. All of the thirteen speeds are controlled with one shift lever. Built into the shift knob of the lever, are a range selection lever and a splitter control button (on the side of the shift knob), that control range selec- tion and gear splits, respectively. Low gear in the front section is used only as a start- ing ratio. The remaining four forward positions are used once in the low range and once in the high range.
However, each of the four high range gear positions can be split with the overdrive ratio of the splitter gear. Ratios cannot be split while the trans- mission is in low range. 4. Release the clutch pedal, and allow the engine to decelerate until the road speed and the engine RPM match. 5. Partially depress the clutch pedal, and move the shift lever into 1st gear. 6. Double clutch to continue upshifting until in fourth gear. See Table 8.3 . Operation, Meritor Splitter and Range-Shift 7.
To upshift into high range—with the transmission still in 4th gear—push the range selection lever up to put the transmission into high range, then partially depress the clutch pedal and move the shift lever into neutral. As the shift lever passes through neutral, the transmission will automati- cally shift from low range to high range. IMPORTANT: The shifter knob has an interlock feature that prevents the splitter control button from being moved up when the range selection lever is down (in the low range); when the trans- mission is in the high range, and the splitter control button is up, the range selection lever cannot be moved down. 8.
Release the clutch pedal, and let the engine slow until the road speed and engine RPM match. 9. Partially disengage the clutch, and move the shift lever into 5th gear. 8.19