Freightliner FLD Conventional — FLD Conventional

Transmissions Shifting Into a Starting Gear 1.6 Move the shift lever to the next higher gear. CAUTION 2. To upshift through the rest of the gears, repeat the substeps above. Before each upshift, push the top of the shift-intent switch into the shift handle body to break torque. The range shift is automatic. Always use the proper starting gear. Do not shift into neutral and coast, as this will result in dam- age to the transmission. 1. Press the system switch down, into the ON posi- tion, to activate the ESS system. 3. To skip a gear, press the shift-intent switch into the shift handle body, while in neutral, one time for every gear that is skipped. 2.

Press the top portion of the shift-intent switch. Downshifting IMPORTANT: Use the clutch brake only when initially engaging a gear with the vehicle stand- ing still. 1. To downshift into the next lower gear. 1.1 Press the bottom portion of the shift-intent switch. 3. Push the clutch pedal to the bottom of its travel so that the clutch brake stops the transmission input shaft from rotating. 1.2 Apply pressure with the shift lever toward the neutral position. 4. Move the shift lever and engage a starting gear. 5. Slowly release the clutch pedal.

1.3 Press the bottom portion of the shift-intent switch again, far enough so that the switch goes into a second position inside the body of the shift knob. Then release the switch. See Fig. 8.21 . This will break torque. NOTE: If you do not shift the transmission out of neutral into a gear within two seconds, the ESS system will "time out" and deactivate. The trans- mission returns to manual operation. To reacti- vate the ESS system, press the shift-intent switch again. See the following procedures for upshifting and downshifting for instructions on how to use the shift-intent switch. 1.4 Immediately move the shift lever to the neutral position.

1.5 Allow engine rpm to speed up enough to synchronize with road speed. 1.6 Move the shift lever to the next lower gear. Upshifting 1. To upshift into the next higher gear: 1.1 Press the top portion of the shift-intent switch. 2. To downshift through the rest of the gears, re- peat the substeps above. Before each downshift, push the bottom of the shift-intent switch into the shift handle body to break torque. The range shift is automatic. 1.2 Apply pressure with the shift lever toward the neutral position. 1.3 Press the top portion of the shift-intent switch again, far enough so that the switch goes into a second position inside the body of the shift handle. Then release the switch. See Fig.

8.20 . This will break torque. 3. To skip a gear, press the shift-intent switch into the shift handle, while in neutral, one time for every gear that is skipped. Reverse 1. Press the system switch on the shift handle so that it is in the ON position and the ESS system is activated. 1.4 Immediately move the shift lever to the neutral position. 1.5 Allow engine rpm to slow down enough to synchronize with road speed. 2. Push the clutch pedal to the bottom of its travel so that the clutch brake stops the transmission input shaft from rotating. 8.22