Rear Axles A In the LOCK position, the interaxle differential is locked out and the driveshaft becomes a solid con- nection between the two axles. Power entering the forward axle is also transmitted straight through to the rear axle, so both axles turn together at the same speed. The LOCK position should be used when the vehicle encounters poor traction conditions; however, it also increases drivetrain and tire wear and should be used only when improved traction is required. B Meritor Interaxle Differential Lockout Operation 02/09/96 f350079a A. Turning Radius When Differential is Locked (engaged)—Understeer Condition B.
Turning Radius When Differential is Unlocked (disengaged) To lock the interaxle differential and achieve maxi- mum pulling power when approaching slippery or poor road conditions, move the lockout control valve to LOCK while maintaining vehicle speed, before en- countering the poor road conditions. Let up momen- tarily on the accelerator to engage the differential lock. Proceed over poor road conditions with caution. Do not wait until traction is lost and the tires are spinning before locking the interaxle differential. Fig. 9.1, Turning Radius When the differential lock disengages, the indicator light will go off and the buzzer will stop.
Meritor Tandem Drive Axles With Interaxle Differential CAUTION Meritor tandem drive axles with an interaxle differen- tial have a lockout feature. Differential lockout is con- trolled by a switch ( Fig. 9.2 ) on the control panel. Do not actuate the interaxle differential control valve while the tires are slipping. Do not operate the vehicle continuously with the interaxle differ- ential locked during extended good road condi- tions. To do so could result in damage to the axle gearing and excessive tire wear. To unlock the interaxle differential, move the lockout control valve to UNLOCK while maintaining vehicle speed, after leaving the poor road conditions.
Let up momentarily on the accelerator to allow the shift, then resume driving at normal speed. Eaton Single Reduction Axles With Controlled Traction Differential 01/19/95 f600306 Fig. 9.2, Interaxle Differential Control The controlled traction differential system is a differ- ential assembly incorporating a friction plate assem- bly designed to transfer torque from the slipping wheel to the one with traction. The unit is basically a multiple disc clutch designed to slip above predeter- mined torque values. This controlled slipping charac- teristic at higher torque values enables the vehicle to negotiate turns in a normal manner.
Resistance to slippage at lower torque values enables the vehicle In the UNLOCK position, there is differential action between the two axles. The differential compensates for different wheel speeds and variations in tire size. Keep the interaxle differential unlocked for normal driving on roads where traction is good. 9.2