Freightliner FLD Conventional — FLD Conventional

Rear Axles to maintain an appreciable amount of tractive effort when one wheel encounters relatively poor traction. A control valve ( Fig. 9.3 ) in the cab is actuated by the driver to engage and disengage the controlled traction feature. A B 01/19/95 f260056a A. High Range B. Low Range Fig. 9.4, Range Preselection Lever moving on the highway, the axle can be shifted to high range. To shift the axle to the high range: Make sure the interaxle differential lockout is disengaged, keep the throttle pedal down, move the range preselection lever to high, release the throttle pedal until the axle shifts, then accelerate. f600307 10/04/93 Fig.

9.3, Traction-Control-Differential Control To shift the axle to the low range: Keep the throttle pedal down, move the range preselection lever to low, release and depress the throttle pedal quickly to increase engine rpm. The axle will shift to low range. Disengaged, the axle has differential action all the time. One wheel will spin independently of the other, if slippery conditions are encountered. Engaged, wheel slippage and spinout are minimized. NOTE: The controlled traction differential can be engaged at any speed, except during spinout. NOTE: When parking the vehicle, put the axle in the low range with the engine running.

Engage the clutch and transmission to be sure the axle has completed the shift into the low range. Some vehicle motion is required to ensure en- gagement of the axle. Eaton 2-Speed Tandem Axles Each axle of the 2-speed tandem contains a high range single reduction gear set and a low range double reduction gear set. The operator selects the desired axle range by moving the range preselection lever located on the shifter knob ( Fig. 9.4 ). IMPORTANT: See "Eaton Interaxle Differential Lockout Operation" for precautions that must be taken when shifting axles in relation to the inter- axle differential lockout.

Dual Range 2-Speed Tandem Axle Operation With Multispeed Transmissions Eaton Interaxle Differential Lockout Operation NOTE: See Chapter 8 , "Transmissions," for de- tailed information on how to use the range pre- selection lever. Interaxle differential lockout systems include a lock- out control valve ( Fig. 9.5 ) located in the cab, and an air-operated shift unit mounted on the forward rear axle. On multispeed transmission applications, the 2-speed axle should be used as a dual range. Use the low range when operating off-highway or when starting out with a heavy load on-highway.

After the vehicle is When the interaxle differential lockout control valve is in the LOCK position, the interaxle differential is locked out and the driveshaft becomes a solid con- nection between the two axles. Power entering the forward axle is also transmitted straight through to 9.3