Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings 1 2 2 1 3 3 4 4 A B f310532 07/26/96 A. Closed Position, Locked B. Open Position, Unlocked 1. Release Arm 2. Release Handle 3. Lock Pin 4. Hinged Lock Fig. 10.7, Type "A" Kingpin Lock Mechanism chocks. Check for correct maximum clearance between the lock halves. If more than 1/8-inch (3.2-mm) clearance exists between the lock halves, the lock must be adjusted. See Group 31 of the Heavy-Duty Trucks Service Manual for adjustment procedures. 11. The load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle.

Determine the front and rear axle weights by weighing the vehicle on scales designed for this purpose. NOTICE The maximum axle weight ratings are shown on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no instances should the axle load exceed the maximum axle weight rat- ing given on the FMVSS or CMVSS label. Always make sure the connect-hanger/support keeps the trailer air hoses and electrical cables positioned so that they do not rub on anything.

Rubbing may wear through hoses or cables, re- sulting in air leaks, or exposed or broken wires, potentially affecting trailer brake or electrical sys- tems. 7. After lockup is completed, connect the tractor-to- trailer air system lines and electrical cable to the trailer. Take care to prevent dirt or foreign mate- rial from entering the air lines. WARNING Do not overload any tractor axle by improperly loading the trailer. This could cause erratic steer- ing and loss of vehicle control, possibly resulting in serious personal injury or death. 8. Charge the air brake system with air. Make sure that the air connections do not leak. 9.

Retract the trailer landing gear and secure the ratchet handle. Unlocking the Fifth Wheel Lock Mechanism 10. Remove the chocks from the trailer tires. 1. Apply the tractor parking brakes. 10.4