Fifth Wheels and Trailer Couplings 2. Pull the trailer air supply valve to cut off the air supply to the trailer. 3. Chock the front and rear of the trailer tires to prevent the trailer from moving. 5th WHEEL SLIDE WARNING LOCK Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes. This applies the trailer service brakes only. As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. MUST BE LOCKED WHEN VEHICLE IS IN MOTION 02/09/94 f310047a 22−11571−3 4.
Lower the trailer landing gear until the weight is removed from the fifth wheel. Fig. 10.8, Fifth Wheel Slide Control Switch 2.2 For double manual release slide models, pull both plunger release handles ( Fig. 10.3 ) outward, from each side of the mounting brackets, to the unlocked posi- tion. Position the plunger holdout latch in the groove of the plunger. See Fig. 10.9 . 5. Disconnect the tractor-to-trailer air system lines and electrical cable. Plug the air lines to prevent dirt or foreign material from entering the lines.
CAUTION Before attempting to lock or unlock the fifth wheel lock mechanism of a sliding type fifth wheel, the slide release plungers must be in the locked position (flush with the mounting bracket edge). This prevents the sliding member from moving rapidly to the far forward or rearward po- sition, which could damage the fifth wheel mem- ber or kingpin. For single lever release slide models, use the release hook to pull the lever to the unlocked position ( Fig. 10.7 ). Lift the re- lease lever to the secure position behind the catch. Visually check the slide plung- ers to make sure they have released as shown in Fig. 10.9 . 3.
Lower the trailer landing gear just enough to re- move the weight from the tractor. 6. Release the kingpin locking mechanism by pull- ing the kingpin lock control handle ( Fig. 10.1 ) to the outward position. 4. Pull the trailer air supply valve to cut off the air supply to the trailer. 7. Slowly drive the tractor away from the trailer. 5. Chock the front and rear of the trailer tires to prevent the trailer from moving. Fifth Wheel Slide Operation WARNING 1. Connect the trailer kingpin to the tractor fifth wheel. For instructions, refer to Holland "Fifth Wheel Locking Operation," in this chapter. Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes.
This applies the trailer service brakes only. As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. 2. After positive lockup of the fifth wheel lock mechanism has been accomplished, release the sliding member using one of the following meth- ods: 2.1 For air-operated models, set the cab- operated control switch ( Fig. 10.8 ) to UNLOCK. 6. Slowly move the tractor forward or backward until the fifth wheel is in the desired location. 10.5