Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings lockup may allow disengagement of the tractor from the trailer, possibly resulting in serious per- sonal injury or death. 8.1 For air-operated models, set the cab- operated control switch to LOCK. Visually check the slide plungers to make sure they are engaged in the fully locked posi- tion. A 1 8.2 For double manual release models, lift the plunger holdout latch on each side of the mounting brackets. Then, move the re- lease plunger on each side of the mount- ing brackets ( Fig. 10.3 ) into the locked position. Make sure that the slide plungers are engaged in the fully locked position. See Fig. 10.9 .

8.3 For single manual release models, trip the release lever ( Fig. 10.4 ) to allow the slide plungers to retract to the locked position. Visually check the slide plungers to make sure they are in the locked position as shown in Fig. 10.9 . 1 B 01/24/96 f310439 A. Locked (engaged) B. Unlocked (disengaged) 1. Plunger 9. The amount of load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle. Fig. 10.9, Plunger Positions Determine the front and rear axle weights by weighing the vehicle on scales designed for this purpose.

CAUTION The maximum axle weight ratings are shown on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no instances should the axle load exceed the maximum axle weight rat- ing given on the FMVSS or CMVSS label. After moving the fifth wheel to the desired posi- tion, be sure the trailer landing gear will not, at any time, come in contact with the tractor frame or other components.

Make sure that the front of the trailer will not come in contact with the rear of the cab or with other components if they ex- tend beyond the rear of the cab. 7. Apply the tractor parking brakes. WARNING NOTE: The fifth wheel may have to be moved slightly to enable the locking plungers to enter the fully locked position. Adjust the fifth wheel slide correctly, and do not overload any tractor axle by incorrectly loading the trailer. Incorrect slide adjustment or improper axle loading could cause erratic steering and loss of vehicle control, possibly resulting in seri- ous personal injury or death. 8. Lock the sliding member into position using one of the following methods:

WARNING Check to be sure that the slide plungers are in the locked position. Failure to achieve complete 10.6