Fifth Wheels and Trailer Couplings Fifth Wheel Lubrication 4 5 The fifth wheel plate must be kept well lubricated with chassis grease to prevent friction and binding between the tractor fifth wheel plate and the trailer. Friction and binding, caused by insufficient grease on the fifth wheel plate, could result in erratic steering. For lubrication instructions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual. 3 6 8 3 ASF Castloc ® II and Simplex ® Series Fifth Wheels General Information 2 1 7 04/08/96 f310445 The ASF Castloc II and Simplex series fifth wheels are used for pulling trailers having the standard 2-inch diameter kingpin. When installed as a station- ary fifth wheel ( Fig.
10.10 ), they are bracket-mounted to the tractor frame in a position that best distributes the trailer load over the tractor axles. When used as a sliding fifth wheel ( Fig. 10.11 ), they are mounted on the Taperloc ® sliding mount (air-operated or manual release). 1. Baseplate 2. Bolted Stop 3. Baseplate Rail 4. Fifth Wheel Mount 5. Slide Saddle Plate 6. Safety Latch 7. Operating Rod 8. Operating Lever Fig. 10.11, Taperloc Slide, Manually-Operated Release Touchloc ® , by a dash mounted release-knob, which activates an air cylinder underneath the top plate. The air cylinder activates the operating rod.
The op- erating rod is located on the left side of the fifth wheel for Castloc II and Simplex II fifth wheels, and on the right side for the Simplex fifth wheel assem- bly. 1 2 On sliding fifth wheels, the top plate is mounted on a sliding saddle plate, which slides along the baseplate attached to the tractor frame. The baseplate rails allow forward and rear movement of the slide assem- bly, for optimum weight distribution over the tractor axles. 3 4 Tapered slots in the baseplate rails, aligned in 4-inch (102-mm) increments, provide for location of the fifth wheel along the baseplate.
Retractable, spring- actuated lockpins are positioned through the slots to hold the fifth wheel in the desired position. The lock- pins are retracted either manually or by an air- operated cylinder controlled from the cab. 11/28/95 f310353b 1. Lubricant Grooves 2. Safety Latch 3. Operating Rod 4. Mounting Bracket Fig. 10.10, Simplex Stationary Fifth Wheel The manually-operated slide contains an operating rod ( Fig. 10.11 ), which unlocks both sides of the plate at the same time. The fifth wheel lock mechanism for the trailer kingpin consists of a rotating jaw that grips the trailer kingpin and a spring-actuated lock. The jaw rotates on a jaw pin during coupling and uncoupling operations.
King- pin lockup occurs when the kingpin is forced into the jaw and the operating rod handle moves to the locked position. The kingpin is released either by ac- tivating a manual operating rod, or if equipped with The air-operated sliding saddle plate contains an air cylinder which moves the operating lever to unlock both sides of the plate at the same time. The air cyl- inder is activated by a two-position air-control valve in the tractor cab. 10.7