Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings Fifth Wheel Lock Mechanism for Trailer Kingpin (Fig. 10.12) pin to move out of the mechanism. With the jaw in the fully open position, the operating rod drops out of the lockset position, and the fifth wheel is ready for coupling. See Fig. 10.13 . 2 3 4 1 1 5 6 2 A 3 1 B C 04/08/96 f310446 A. Locked Position B. Jaw movement compresses spring. C. Fully open. 1. Operating Lever 2. Safety Latch 3. Jaw 4. Jaw Eccentric Pin 5. Lock 6. Spring 04/08/96 f310447 1. Safety Latch 2. Operating Rod (locked) 3. Operating Rod (unlocked) Fig. 10.12, ASF Castloc II and Simplex Series Kingpin Locking Mechanism Operation Fig.

10.13, Simplex Kingpin Locking Mechanism, Locking and Unlocking The Castloc II and Simplex Series fifth wheel lock mechanism consists of a rotating jaw and a spring- actuated lock that grips the trailer kingpin. The jaw rotates on an eccentric pin during coupling and un- coupling operations. The spring-actuated lock holds the jaw in the locked position once kingpin lockup has occurred. During coupling, the kingpin contacts and rotates the jaw into the locked position. This action automatically moves the operating rod into the locked position. This securely locks the jaw around the kingpin. In the locked position the safety latch swings freely over the operating rod. See Fig. 10.14 .

In the locked position, there is approximately 1/16- inch (1.6-mm) clearance between the jaw and king- pin. The jaw eccentric pin can be removed and ro- tated to compensate for wear and maintain an approximate 1/16-inch (1.6-mm) clearance during service. Fifth Wheel Locking and Unlocking Locking the Fifth Wheel Lock Mechanism 1. Chock the front and rear of the trailer tires to prevent the trailer from moving. Placing the operating rod in the lockset position moves the lock away from the jaw. This action un- locks the jaw so that it can be rotated by movement of the kingpin.

When the tractor is moved out from under the trailer, the kingpin will rotate the jaw until the jaw is in the unlocked position, allowing the king- CAUTION Before attempting to lock the fifth wheel lock mechanism of a sliding type fifth wheel, the slide locking handle ( Fig. 10.11 ) must be in the locked position. This prevents the sliding member from 10.8