Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings throat of the locking mechanism. Continue back- ward motion until positive lockup occurs. 6. Apply the tractor parking brakes. 7. Make a visual check (even if equipped with the Touchloc air-operated system) for positive king- pin lockup. The trailer bed plate must be flush on the fifth wheel plate surface. When positive lockup has occurred, the fifth wheel operating rod will have moved inward to the locked posi- tion, and the safety latch will swing freely over the operating rod. See Fig. 10.14 . 1 2 11/18/94 f310448 1. Safety Latch 2. Operating Rod NOTE:

Only when the operating rod is fully re- tracted in the locked position will the safety latch be freely rotated down. Fig. 10.14, Simplex Kingpin Locking Mechanism, Safety Latch (locked position) moving rapidly to the far forward or rearward po- sition, which could damage the fifth wheel mem- ber or kingpin. 8. Release the tractor parking brakes. Test for king- pin lockup by pulling on the trailer against the chocks. 2. The fifth wheel jaw must be fully open. Make sure that the operating rod is in the unlocked po- sition. The fifth wheel must be completely lubri- cated with chassis or multi-purpose grease. For lubrication instructions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual.

NOTICE Always make sure the connect-hanger/support keeps the trailer air hoses and electrical cables positioned so that they do not rub on anything. Rubbing may wear through hoses or cables, re- sulting in air leaks, or exposed or broken wires, potentially affecting trailer brake or electrical sys- tems. WARNING Keep the fifth wheel plate lubricated to prevent binding between the tractor and trailer. A binding fifth wheel could cause erratic steering and loss of vehicle control, possibly resulting in serious personal injury or death. 9. After lockup is completed, connect the tractor-to- trailer air system lines and electrical cable to the trailer.

Take care to prevent dirt or foreign mate- rial from entering the air system lines. 3. Make sure the fifth wheel top plate is tilted so the ramps are as low as possible. If equipped with an air suspension, make sure the air bags are completely inflated. 10. Charge the air brake system with air. Make sure that the air connections do not leak. WARNING 4. Position the tractor so that the center of the fifth wheel is in line with the trailer kingpin. The king- pin should be in a position to enter the throat of the locking mechanism. See Fig. 10.12 .

Adjust the trailer landing gear so that the lower front trailer edge contacts the top surface of the tilted fifth wheel plate, approximately 8 inches (20 cm) before the fifth wheel center. Adjust the jaw pin if there is more than 1/8-inch (3-mm) clearance between the kingpin and the lock. Incorrect adjustment could cause the trailer to disconnect, possibly resulting in serious per- sonal injury or death. 11. With the trailer wheels chocked and the brakes set, check for clearance between the kingpin and the fifth wheel jaws by moving the tractor forward and backward against the locked kingpin. A clearance of approximately 1/16 inch (1.6 mm) between the jaw and kingpin is allowable.

When clearance between the jaw and kingpin exceeds 5. With the fifth wheel lock opening aligned with the trailer kingpin, back the tractor slowly toward the trailer, making sure that the kingpin enters the 10.9