Fifth Wheels and Trailer Couplings 5. Pull the trailer air supply valve to cut off the air supply to the trailer. 2 4 5 1 3 CAUTION 6 After moving the fifth wheel to the desired posi- tion, be sure the trailer landing gear will not, at any time, come in contact with the tractor frame or other components. Make sure that the front of the trailer will not come in contact with the rear of the cab or with other components if they ex- tend beyond the rear of the cab. 7 8 9 6. Slowly move the tractor forward or backward until the fifth wheel is in the desired location. 7. Apply the tractor parking brakes.
WARNING f310544 10/17/96 Check to be sure that the lockpins are seated in the holes and that the operating rod is in the locked position with the safety latch securing the operating rod. Failure to achieve complete lockup may cause the trailer to detach from the tractor, possibly resulting in serious personal injury or death. 1. Housing Weldment 2. Air Cylinder 3. Extension Spring 4. Slide Cam 5. Lock Control Handle 6. Lever Bar 7. Lock Spring 8. Lock 9. Jaw Fig. 10.15, Touchloc Air-Operated Lock Control NOTE: The fifth wheel may have to be moved slightly to enable the locking pins to enter the fully locked position. Fifth Wheel Slide Operation 1.
Chock the front and rear of the trailer tires to prevent the trailer from moving. 8. Lock the sliding member into position using one of the following methods: 2. Connect the trailer kingpin to the tractor fifth wheel. For instructions, refer to "Fifth Wheel Locking Operation," in this chapter. For air-operated models: Set the cab-operated control switch to LOCK. Visually inspect the lock- pins to make sure they have seated in the base- plate rail holes. 3. After positive lockup of the fifth wheel lock mechanism has been accomplished, release the slide using one of the following methods: For manually-operated models: Raise the operat- ing rod so that it is free to move inward.
Make sure that the lockpins have seated in the base- plate rail holes and the operating rod moves into the locked position. Also, the safety latch must drop downward so that it holds the operating rod in the locked position. 3.1 For air-operated models, set the cab- operated control switch ( Fig. 10.8 ) to UN- LOCK. 3.2 For manually-operated models, raise the safety latch and pull the slide operating rod ( Fig. 10.11 ) outward until the shoulder is outside of the operating rod support, then lower the operating rod as far as it will go. 9. The amount of load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle.
Determine the front and rear axle weights by weighing the vehicle on scales designed for this purpose. 4. Lower the trailer landing gear just enough to re- move the weight from the tractor. 10.11