Fifth Wheels and Trailer Couplings The maximum axle weight ratings are shown on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no instances should the axle load exceed the maximum axle weight rat- ing given on the FMVSS or CMVSS label. forced into the jaws and the lock control handle moves to the locked position. The fifth wheel top plate is mounted on a slide as- sembly, which is attached to slide rails that are mounted on the vehicle frame.
The slide rails permit forward and rearward movement of the slide assem- bly, allowing for optimum weight distribution over the tractor axles. WARNING Slots are evenly spaced along the slide rails and re- tractable lockpins are positioned through the holes to hold the fifth wheel in the desired position. See Fig. 10.16 or Fig. 10.17 . Adjust the fifth wheel slide correctly, and do not overload any tractor axle by incorrectly loading the trailer. Incorrect slide adjustment or improper axle loading could cause erratic steering and loss of vehicle control, possibly resulting in seri- ous personal injury or death.
1 Fifth Wheel Lubrication WARNING Keep the fifth wheel plate lubricated to prevent binding between the tractor and trailer. A binding fifth wheel could cause erratic steering and loss of vehicle control, possibly resulting in serious personal injury or death. The fifth wheel plate must be kept well lubricated with chassis grease to prevent friction and binding between the tractor fifth wheel plate and the trailer. For lubrication instructions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual. 07/25/95 f310189 1. Locking Wedge 2. Air Cylinder Fontaine ® Fifth Wheels General Information Fig.
10.16, Air-Operated Sliding Fifth Wheel Mount, AWB Model The slide portion of the sliding model may be at- tached to either an air-operated release slide, or a manual release slide. The Fontaine sliding fifth wheel mount is designed to provide optimum axle loading for maximum tractor use with different lengths and types of trailers. The sliding fifth wheel mount is used with the Fontaine H5092 series, and 6000/7000 No-Slack II series fifth wheels, and is equipped with either an air-operated release slide (AWB or HAWB models) or a manual release slide (MWS or HMWS models). The air-operated release slide contains an air cylin- der that locks and unlocks the fifth wheel slide. See Fig. 10.16 .
The air cylinder is activated by a two- position air-control valve in the tractor cab. The manual release slide contains a slide locking control handle, located on the left side of the fifth wheel, which locks or unlocks the fifth wheel slide. See Fig. 10.17 . On Fontaine fifth wheels, kingpin release is accom- plished by activating a manual lock control handle located on either the right side or left side of the fifth wheel. Kingpin lockup occurs when the kingpin is 10.12