Fifth Wheels and Trailer Couplings loss of vehicle control, possibly resulting in seri- ous personal injury or death. 3. Models 260 and 460: Back up the vehicle until the drawbar eye is over the pintle hook, then lower the trailer. Fifth Wheel Lubrication Model 690: Back up the vehicle until the drawbar eye enters the open jaw, contacts the back of the pintle hook, and closes the coupling. The fifth wheel plate must be kept well lubricated with chassis grease to prevent friction and binding between the tractor fifth wheel plate and the trailer. Friction and binding, caused by insufficient grease on the fifth wheel plate could result in erratic steering.
For lubrication instructions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual. 4. Close the coupling. Models 260 and 460: Push in on the pawl wedges and lift the pawl assembly. The latch will drop into the closed position. Lock the latch by lowering the pawl assembly. Premier Trailer Couplings General Information Model 690: The pintle hook will automatically close and lock from the pressure of the drawbar eye against it. Install the linchpin. Trailer couplings, used only on trucks, are attached to the rear closing crossmember. NOTICE The Premier 260 and 460 trailer couplings ( Fig. 10.21 ) have a rigid pintle hook, and are air- adjusted.
An air chamber, mounted forward of the coupling, operates a push rod, which pushes against a shoe inside the coupling. The shoe maintains con- stant pressure on the eye of the trailer drawbar when it’s over the pintle hook. This takes up any slack in the trailer connection, providing smoother towing and less wear on the pintle hook. The air pressure is acti- vated when the trailer brakes are released. Always make sure the connect-hanger/support keeps the trailer air hoses and electrical cables positioned so that they do not rub on anything.
Rubbing may wear through hoses or cables, re- sulting in air leaks, or exposed or broken wires, potentially affecting trailer brake or electrical sys- tems. 5. Hook up the trailer’s electrical and air lines. 6. Remove the chocks from the trailer’s tires. The Premier 690 trailer coupling ( Fig. 10.22 ) has a moveable pintle hook, and is non-air adjusted. It is used for heavy-duty applications. Trailer Release 1. Apply the truck and trailer parking brakes. Operation Trailer Hookup WARNING 1. Chock the front and rear tires of the trailer. Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes. This applies the trailer service brakes only.
As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. 2. Open the coupling. Models 260 and 460 ( Fig. 10.21 ): Pull up on the pawl lock; then, while squeezing the pawl wedges together, lift up the pawl assembly. Lift up the latch, and push it up against the pawl as- sembly, locking the latch in place. 2. Chock the front and rear tires of the trailer. Model 690 ( Fig. 10.22 ): Remove the linchpin from the handle, then push in on the handle and turn it toward you. Open the pintle hook by pull- ing it down and toward you.
Release the handle, locking the pintle hook open. 3. Disconnect the trailer air and electrical lines. Plug the air lines to keep out dirt. 4. Take the weight of the trailer drawbar eye off the pintle hook. 5. Open the coupling. 10.17