Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings WARNING Check to be sure that the lockpins are seated in the holes. Failure to achieve complete lockup may cause the trailer to detach from the tractor, possibly resulting in serious personal injury or death. 8.1 For air-operated release models, set the cab-operated slide control switch to LOCK. Visually inspect the lockpins to make sure that they are fully inserted in the slide rail holes. 05/19/94 f310050 8.2 For manual release models, disengage the slide locking handle from the guide plate. The slide locking handle is spring- loaded in the locked position and will seek the locked position when disengaged from the guide plate.

The fifth wheel may have to be moved slightly to enable the locking pins to fully enter the locked position. When the slide lock control handle returns to the fully in position, visually and physi- cally check the lockpins to make sure they are fully inserted into the holes in the slide rails. Make sure the slide locking handle is locked in position against the guide plate. Fig. 10.20, Fontaine 5000 Series Sliding Fifth Wheel Manual Release This applies the trailer service brakes only. As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. 5.

Chock the front and rear of the trailer tires to prevent the trailer from moving. CAUTION 9. The amount of load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle. After moving the fifth wheel to the desired posi- tion, be sure the trailer landing gear will not, at any time, come in contact with the tractor frame or other components. Make sure that the front of the trailer will not come in contact with the rear of the cab or with other components if they ex- tend beyond the rear of the cab. Determine the front and rear axle weights by weighing the vehicle on scales designed for this purpose.

The maximum axle weight ratings are given on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no instances should the axle load exceed the maximum axle weight rat- ing given on the FMVSS or CMVSS label. 6. Slowly move the tractor forward or backward until the fifth wheel is in the desired location. 7. Apply the tractor parking brakes. NOTE: The fifth wheel may have to be moved slightly to enable the locking pin(s) to enter the fully locked position. 8.

Lock the sliding member in position using one of the following methods: WARNING Adjust the fifth wheel slide correctly, and do not overload any tractor axle by incorrectly loading the trailer. Incorrect slide adjustment or improper axle loading could cause erratic steering and 10.16