Fifth Wheels and Trailer Couplings 11. Retract the trailer landing gear, and secure the ratchet handle. Remove the chocks from the trailer tires. 5. Disconnect the tractor-to-trailer air system lines and electrical cable. Plug the air lines to prevent dirt or foreign material from entering the lines. 12. The load distribution on the front steering axle and rear drive axle(s) will have a direct effect on the steering control of the vehicle. CAUTION Before attempting to lock or unlock the fifth wheel lock mechanism of a sliding type fifth wheel, the slide locking handle, if so equipped, and the slide lockpins must be in the locked po- sition (fully inserted in the slider rail holes).
This prevents the sliding member from moving rapidly to the far forward or rearward position, which could damage the fifth wheel member or kingpin. Determine the front and rear axle weights by weighing the vehicle on scales designed for this purpose. The maximum axle weight ratings are given on the Federal Motor Vehicle Safety Standard (FMVSS) label or Canadian Motor Vehicle Safety Standard (CMVSS) label attached to the left rear door post of the tractor. The desired load on the axle is no less than 80 percent of the maximum axle weight rating, but in no instances should the axle load exceed the maximum axle weight rat- ing given on the FMVSS or CMVSS label. 6.
Release the kingpin locking mechanism by lifting the safety latch and pulling the lock control handle to the unlocked position. See Fig. 10.19 . 7. Slowly drive the tractor away from the trailer. WARNING Fifth Wheel Slide Operation Do not overload any tractor axle by improperly loading the trailer. This could cause erratic steer- ing and loss of vehicle control, possibly resulting in serious personal injury or death. 1. Connect the trailer kingpin to the tractor fifth wheel. For instructions, refer to Fontaine 5000 Series "Fifth Wheel Locking Operation," in this chapter. Unlocking the Fifth Wheel Lock Mechanism 2.
After positive lockup of the fifth wheel lock mechanism has been accomplished, release the slide using one of the following methods: 1. Apply the tractor parking brakes. 2.1 For air-operated release models, set the cab-operated control switch to UNLOCK. 2. Pull the trailer air supply valve to cut off the air supply to the trailer. 2.2 For manual release models, lift the slide locking handle to disengage it from the guide plate. Then, pull out the handle ( Fig. 10.20 ) until it is in the unlocked posi- tion and can be positioned against the guide plate to hold it out. The slide locking handle will stay in the unlocked position until it is manually disengaged from the guide plate.
WARNING Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes. This applies the trailer service brakes only. As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. 3. Lower the trailer landing gear just enough to re- move the weight from the tractor. 3. Chock the front and rear of the trailer tires to prevent the trailer from moving. 4. Pull the trailer air supply valve to cut off the air supply to the trailer. 4. Lower the trailer landing gear until the weight is removed from the fifth wheel.
WARNING Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes. 10.15