Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings WARNING Keep the fifth wheel plate lubricated to prevent binding between the tractor and trailer. A binding fifth wheel could cause erratic steering and loss of vehicle control, possibly resulting in serious personal injury or death. 1 2. The kingpin lock mechanism must be fully open, the fifth wheel plate must be completely lubri- cated with chassis grease. For lubrication in- structions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual. A 2 1 3. Position the tractor so that the fifth wheel lock opening is in line (both vertically and horizontally) with the trailer kingpin.

The kingpin should be in a position to enter the throat of the locking mechanism, as shown in Fig. 10.18 . Adjust the trailer landing gear to give enough alignment height for positive kingpin lockup. 2 02/09/95 f310110a B 4. With the fifth wheel lock opening aligned with the trailer kingpin, back the tractor slowly toward the trailer, making sure that the kingpin enters the throat of the locking mechanism. Continue back- ward motion until positive lockup occurs. NOTE: Make sure the safety latch is down when the control handle is locked. A. Unlocked B. Locked 1. Safety Latch 2. Lock Control Handle Fig. 10.19, Fontaine 5000 Series Fifth Wheel, Locking and Unlocking 5.

Apply the tractor parking brakes. 6. Make a visual and physical check for positive kingpin lockup. When lockup has occurred, the fifth wheel control handle will have moved to the locked position. Make sure that the safety latch is down over the lock control handle. See Fig. 10.19 . This will hold the control handle in the locked position. the trailer. Take care to prevent dirt or foreign material from entering the air system lines. 9. Charge the air brake system with air. Make sure that the air connections do not leak. WARNING 7. Release the tractor parking brakes. Test for king- pin lockup by pulling on the trailer against the chocks. Eliminate slack between the trailer and the trac- tor.

Incorrect fifth wheel adjustment could cause the trailer to disconnect, possibly resulting in se- rious personal injury or death. NOTICE 10. With the trailer wheels chocked and the brakes set, check for clearance between the kingpin and the fifth wheel jaws by moving the tractor forward and backward against the locked kingpin. There should be no slack between the tractor and the trailer. If slack is present, uncouple the trailer. Always make sure the connect-hanger/support keeps the trailer air hoses and electrical cables positioned so that they do not rub on anything.

Rubbing may wear through hoses or cables, re- sulting in air leaks, or exposed or broken wires, potentially affecting trailer brake or electrical sys- tems. For adjustment instructions, refer to the appli- cable manufacturer’s service information. 8. After lockup is completed, connect the tractor-to- trailer air system lines and the electrical cable to 10.14