Pretrip and Post-Trip Inspections and Maintenance 1.3 Water and oil emulsion often form pockets that will not drain while compressed air is in the reservoirs. Because of these pock- ets, leave the valves blocked open during the first part of the pretrip inspection. CAUTION Coolant must be filled to the full line of the surge tank. Low coolant could result in engine over- heating, which could cause engine damage. 1.4 If the drained water is cloudy or oily, it may indicate a problem with the compres- sor. If oil is allowed to contaminate the air dryer, it will not remove the water from the air brake system, which could adversely affect braking. 4. Inspect the radiator and charge air cooler.
4.1 Inspect the radiator and charge air cooler for clogged fins. Use compressed air or water directed from the fan side of the core to backflush any material restricting airflow. 2. Check the fluid level in the windshield washer reservoir. 4.2 Inspect the radiator and charge air cooler for damage and accumulated debris. Straighten bent or damaged fins to permit airflow across all areas of the cores. Add washer fluid as needed. Unscrew the cap to add fluid. WARNING NOTE: When traveling through areas of high insect concentration, it may be necessary to clean the exterior of the radiator or the charge air cooler core as often as every 200 miles (320 km). Washer fluids may be flammable and poisonous.
Do not expose washer fluid to an open flame or any burning material, such as a cigarette. Always comply with the washer fluid manufacturer’s rec- ommended safety precautions. 4.3 On vehicles equipped with air condition- ing, also inspect and clean the condenser. If clogged, the condenser can restrict air- flow through the radiator. 3. Check the coolant level in the surge tank. See Fig. 11.1 . If the coolant is low, add a 50/50 mixture of water and the type of antifreeze cur- rently installed in your vehicle. Fill the surge tank with coolant to the MAX line when the tank is cool.
If the surge tank was empty, start the en- gine after refilling and check the level again when the engine is at operating temperature. 4.4 Check the radiator for leaks. If leaks are found, have the radiator repaired or re- placed. See Group 20 of the Heavy-Duty Trucks Service Manual for instructions, or take the vehicle to an authorized Freight- liner dealer. 1 5. Inspect the engine and chassis wiring. Check for loose wiring, chafed insulation, and damaged or loose hold-down clamps. Tighten loose wires or hold-down clamps; replace dam- aged wiring or clamps. 6. Inspect the air intake system for leaks or dam- age.
CAUTION Failure to maintain a sealed air intake system could allow the entry of dirt and contaminants into the engine. This could adversely affect en- gine performance and result in engine damage. 01/20/95 f500030a 1. Filler Neck Fig. 11.1, Coolant Level Checking 6.1 Check the intake-air restriction indicator. 11.4