Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance 6.2 Replace the primary filter element in the air cleaner if the yellow signal stays locked at 25 inH 2 O for Caterpillar and Cummins engines or 20 inH 2 O for Detroit Diesel engines. See Group 09 of the Heavy-Duty Trucks Service Manual for filter element replacement instructions, or take the vehicle to an authorized Freight- liner dealer. 1 2 NOTE: After replacing the filter element, reset the restriction indicator by pressing the rubber reset button. 6.3 Inspect the secondary or safety filter ele- ment in the air cleaner when replacing the primary element, and replace it when clogged or dirty.

This element should be replaced with every third primary element replacement. 02/09/95 f180002 1. Oil Check 2. Oil Fill 6.4 Check the engine air intake piping from the air cleaner to the engine intake. In- spect the piping for loose connections, cracks, torn or collapsed hoses, punc- tures, and other damage. Tighten loose connections, and have damaged compo- nents replaced. Make sure the piping sys- tem is airtight so that all intake air passes through the air cleaner. Fig. 11.2, Oil Level Checking 8.1 Check that the fuel tanks are secured to their mounting brackets and that the mounting brackets are secured to the frame. 8.2 Replace leaking fuel tanks.

8.3 If lines or connections are leaking, have them repaired or replaced. 7. Check the engine oil level. For repair and/or replacement procedures, see Group 47 of the Heavy-Duty Trucks Service Manual, or take the vehicle in to an authorized Freightliner dealer. If the oil level is at or below the minimum fill (or "add") mark on the dipstick, add enough oil to maintain the level between the minimum fill (or "add") and the maximum fill (or "full") marks on the dipstick. See Fig. 11.2 . Engine lube oil must have a sulfated ash level less than 1.0 wt %; currently referred to as CJ-4 oil. Use the proper SAE viscosity rating for the temperature and time of year.

8.4 If equipped with fuel tank shutoff valves, be sure the valves are fully open. WARNING CAUTION Never operate the engine with the fuel tank shut- off valves partly closed. This could damage the fuel pump, causing sudden loss of engine power, possibly resulting in serious personal injury due to reduced vehicle control. Operating the engine with the oil level below the minimum fill (or "add") mark or above the maxi- mum fill (or "full") mark could result in engine damage. 9. Check the fuel level in the fuel tank(s). To keep condensation to a minimum, fuel tanks should be filled at the end of each day.

Federal regulations prohibit filling a fuel tank to more than 95 percent of its liquid capacity. 8. Inspect the fuel tanks, fuel lines, and connections for leaks. 11.5