Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance WARNING For a Webb Model 525 (see Fig. 11.5 ): Turn the drain valve handle. If nothing flows from the valve, it may be blocked. Use a pencil or screw- driver to clear the valve. Allow the water to drain and then close the valve. Start the engine and raise the rpm for two or three minutes to purge any air from the fuel system. Never fill fuel tanks to more than 95 percent of their liquid capacity. This could make them more likely to rupture from impact, possibly causing fire and resulting in serious personal injury or death by burning. Do not mix gasoline or alcohol with diesel fuel.

This mixture could cause an explosion, possibly resulting in serious personal injury or death. Do not fill the fuel tanks in the presence of sparks, open flames, or intense heat. These could ignite the fuel, possibly causing severe burns. For ConMet Models (see Fig. 11.6 ): Check the water level in the sight bowl (if equipped). To drain the water, loosen the valve at the bottom and allow the water to run out. Close and tighten the valve finger-tight. IMPORTANT: Engines manufactured since 2007 must use ultralow-sulfur diesel (ULSD) with 15 ppm sulfur content or less, based on ASTM D2622 test procedure. Failure to use ultralow sulfur diesel fuels may void the war- ranty on emission components.

9.1 Fuel should always be strained or filtered before being put into the tanks. This will lengthen the life of the engine fuel filter and reduce the chances of dirt getting into the engine. 1 9.2 Before installing the fuel cap, clean the area with a rag, or if necessary, clean the cap with solvent. 2 3 02/09/95 f470103 9.3 If needed, prime the fuel system. For priming procedures, see the applicable engine manufacturer’s manual. 1. Sight Bowl 2. Collected Water 3. Drain Valve Fig. 11.3, Racor Fuel/Water Separator 10. Drain the water from the fuel/water separator as follows: IMPORTANT:

When draining fluid from a fuel/ water separator, drain the fluid into an appropri- ate container and dispose of it properly. Many states now issue fines for draining fuel/water separators onto the ground. On all types of separators, stop draining fluid when you see fuel come out of the separator drain valve. For a Racor Model 1000FG (see Fig. 11.3 ): Check the water level in the sight bowl. To drain the water, loosen the valve at the bottom of the bowl two full turns and allow the water to run out. Close and tighten the valve finger-tight. For a Davco Model 321 (see Fig. 11.4 ): If the separator is equipped with a fuel filter and the filter has a vent at the top, open the vent.

To drain the water, open the drain valve at the bot- tom of the separator. Newer separators use a ball valve with a handle that turns 90 degrees. Older separators have a knurled, brass valve that unscrews to open. Allow the water to drain and close the valve finger-tight. 11. Inspect the front and rear suspension compo- nents, including springs, spring hangers, shocks, and suspension brackets. 11.1 Check for broken spring leaves, loose U-bolts, cracks in the suspension brackets, and loose fasteners in the spring hangers and shackles. 11.6