Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance 02/09/95 f470104 03/03/97 f470167a 1 Fig. 11.4, Davco Fuel/Water Separator 1. Drain Valve Fig. 11.6, ConMet Fuel/Water Separator 12.1 Replace the wiper arms if the wiper blades are not tensioned against the wind- shield. 12.2 Replace damaged or deteriorated wiper blades. WARNING When cleaning windshields and windows, always stand on the ground or on a secure ladder or platform. Use a long-handled window cleaner. Do not use the cab steps, tires, fenders, fuel tanks, engine, or under-hood components to access the windshield or windows. Doing so could cause a fall and result in an injury. 02/09/95 f470105 Fig. 11.5, Webb Fuel/Water Separator 13.

Check the oil- and air-pressure warning systems. 11.2 Inspect the shock absorbers for loose fas- teners and leaks. 13.1 Check if the warning systems come on when the ignition is turned on, and if not, have the systems repaired. 11.3 Tighten all loose fasteners and have any component(s) replaced that are worn, cracked, or otherwise damaged. 13.2 Start the engine, then check that the oil- and air-pressure warning systems are op- erating. The buzzer should stop sounding when the preset minimum is reached. If the air pressure in both systems is above the preset minimum when the engine is started, test the low air pressure warning 11.4 On vehicles with air suspensions, check for leaks.

Check air suspension compo- nents for cuts and bulges. 12. Clean the windshield, and the side and rear win- dows, then check the condition of the windshield wiper arms and blades. 11.7