Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance system by lowering the pressure to below this range, or until the warning system comes on. 1 2 The air pressure in both the primary and secondary air reservoir systems must be above 65 psi (448 kPa) on most vehicles. For vehicles with an optional Bendix dryer reservoir module (DRM), the cut-out pres- sure is 130 psi (896 kPa). 14. Make sure that the horn, windshield wipers, and windshield washers are operating properly. These devices must be in good working order for safe vehicle operation. 14.1 Make sure that the horn works. If a horn is not working, have it repaired before trip departure.

6 3 4 5 f000018a 05/08/95 14.2 Check the wiper and washer control on the multifunction turn signal switch. If the wipers and/or washers are not working, have them repaired before trip departure. 1. Clearance Lights 2. Identification Lights 3. Fog Lights 4. Headlights 5. Turn Signals and Side-Marker Lights 6. Intermediate Turn Signal Lights 15. During cold weather, make sure the heater, de- froster, and optional mirror heat controls are op- erating properly. If so equipped, turn on the mir- ror heat switch and make sure the system is working. Fig. 11.7, Exterior Lights 17.4 Be sure all reflectors and lenses are in good condition and are clean. Replace any broken reflectors or lenses. 16.

Check the operation of all the panel lights and interior lights. 18. Check tire inflation pressures using an accurate tire pressure gauge. Tires should be checked when cool. For inflation pressures and maximum loads (per tire) see the tire manufacturer’s guidelines. Turn on the headlights, dash lights, and four-way flashers and leave them on. If any of the gauge bulbs, the dome light bulbs, or the right- and left- turn indicator bulbs are not working, replace them. A weekly pressure loss of 4 psi (28 kPa) or more in a tire may indicate damage. The tire should be inspected and, if necessary, repaired or replaced. 17. Make sure all the exterior lights are working properly.

18.1 Be sure valve stem caps are on every tire and that they are screwed on finger-tight. Check that all the lights and reflectors are clean. See Fig. 11.7 . 18.2 Inflate the tires to the applicable pressures if needed. 17.1 Check that the brake lights, taillights, headlights, parking lights, turn signals, marker lights, identification lights, road lights (if so equipped), and front clearance lights are working properly and are clean. 18.3 If a tire has been run flat or underinflated, check the wheel for proper lockring and side-ring seating, and possible wheel, rim, or tire damage before adding air. Moisture inside a tire can result in body ply separation or a sidewall rupture.

Dur- ing tire inflation, compressed air reservoirs and lines must be kept dry. Use well- maintained inline moisture traps and ser- vice them regularly. 17.2 Test the high and low beams of the head- lights. 17.3 Replace light bulbs or sealed beam units that are not working. 11.8