Pretrip and Post-Trip Inspections and Maintenance WARNING Do not operate the vehicle with underinflated or overinflated tires. Incorrect inflation can stress the tires and make the tires and rims more sus- ceptible to damage, possibly leading to rim or tire failure and loss of vehicle control, resulting in serious personal injury or death. IMPORTANT: The load and cold inflation pres- sure must not exceed the rim or wheel manu- facturer’s recommendations, even though the tire may be approved for a higher load inflation. Some rims and wheels are stamped with a maximum load and maximum cold inflation rat- ing.
If they are not stamped, consult the rim or wheel manufacturer for the correct tire inflation pressure for the vehicle load. If the load ex- ceeds the maximum rim or wheel capacity, the load must be adjusted or reduced. 02/09/95 f400058 Fig. 11.8, Dirt and Rust Streaks from the Stud Holes See Group 33 or Group 35 of the Heavy- Duty Trucks Service Manual for service procedures on the studs and hubs, and see Group 40 in the same manual for wheel and tire servicing, or take the ve- hicle to an authorized Freightliner dealer. 19. Inspect each tire for wear, bulges, cracks, cuts, penetrations, and oil contamination. 19.1 Check the tire tread depth.
If tread is less than 4/32 inch (3 mm) on any front tire, or less than 2/32 inch (1.5 mm) on any rear tire, replace the tire. WARNING Have any worn or damaged wheel components replaced by a qualified person using the wheel manufacturer’s instructions and the wheel indus- try’s standard safety precautions and equipment. Otherwise a vehicle or workshop accident could occur, possibly resulting in serious personal in- jury or death. 19.2 Inspect each tire for bulges, cracks, cuts, and penetrations. 19.3 Inspect each tire for oil contamination. Fuel oil, gasoline, and other petroleum derivatives, if allowed to contact the tires, will soften the rubber and destroy the tire.
20.3 Have broken, cracked, badly worn, bent, rusty, or sprung rings and rims replaced. Be sure that the rim base, lockring, and side ring are matched according to size and type. 20. Check the wheel nuts or rim nuts for indications of looseness. Examine each rim and wheel com- ponent. 20.1 Remove all dirt and foreign material from the assembly. Dirt or rust streaks from the stud holes, metal buildup around stud holes, or out-of-round or worn stud holes may be caused by loose wheel nuts. See Fig. 11.8 and Fig. 11.9 . 20.4 Make sure all wheel nuts are tightened 450 to 500 lbf·ft (610 to 678 N·m) for Ac- curide wheels with unlubricated threads.
20.2 Examine the rim and wheel assembly components (including rims, rings, flanges, studs, and nuts) for cracks, or other dam- age. Use the tightening pattern in Fig. 11.10 for 10-hole wheels, and the tightening pattern in Fig. 11.11 for 8-hole wheels. See Group 40 of the Heavy-Duty Trucks Ser- vice Manual for more information. 11.9