Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance 21.4 Inspect the exterior surfaces of the cham- ber for damage. Make sure that breather holes in the non-pressure section(s) are open and free of debris. See Group 42 of the Heavy-Duty Trucks Service Manualto replace any damaged parts. 1 A 21.5 On all parking brake installations, make sure the end cover cap or dust plug is se- curely snapped into place. NOTE: On most MGM parking brake cham- bers equipped with an integral release bolt, an end cover cap is installed over the re- lease bolt. 21.6 Check for rusted connections, missing snap rings, and damaged camshaft grease seals. Have damaged or missing parts repaired or replaced.

02/22/2000 f421352 A. Do not remove this clamp ring. 1. MGM TR–T (TR Series) Brake Chamber shown 22. Inspect the air brake lines. Fig. 11.12, Parking Brake Chamber Clamp 22.1 Check the clearance between the hoses and the exhaust manifold or other hot spots. Excessive heat will cause material in the hoses to deteriorate rapidly or be- come brittle. Provide at least 6 inches (150 mm) of clearance. More clearance is recommended if the hose is located above the heat source. control resulting in property damage or personal injury. 21.1 Check that the air brake chamber is mounted securely on its mounting bracket, and that there are no loose or missing bolts.

22.2 Check for kinks, dents, or swelling of the hoses. If damaged, have the hose re- placed with the same size and type. 21.2 Look for worn clevis pins on brake cham- ber pushrods and missing or damaged cotter pins on brake chamber pushrod cle- vis pins. Replace worn clevis pins and in- stall new cotter pins if necessary. NOTE: Do not route the hose on top of any- thing likely to be stepped on. 21.3 See if the chamber piston rod is in line with the slack adjuster. Misalignment can cause the piston rod to rub on the non- pressure chamber and cause a dragging brake. See Group 42 of the Heavy-Duty Trucks Service Manual.

22.3 Check for damage to hoses located near moving parts, such as drivelines, kingpins, suspensions, and axles. If moving parts are catching or pinching the lines, correct as needed. 22.4 Check for hose damage caused by abra- sion. If abraded, have the hose replaced. Check for the cause of abrasion, such as loose or damaged hose clamps. Have the clamps repaired or replaced as needed. CAUTION If the external breather tube or breather cap is missing or incorrectly installed, road dirt and de- bris can adversely affect the operation of the brake chamber. Once inside of the chamber, dirt and debris can cause the internal parts of the chamber to deteriorate faster.

22.5 Observe the hose cover condition, espe- cially hoses exposed to water splash and ice. If dried out or ragged (the wire or liner is showing through the cover), have the hose(s) replaced. 11.11