Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance 22.6 Inspect the air tubing, especially tubing made of nylon. In cold weather, nylon tub- ing is sensitive to damage, such as nicks or cuts. Have nicked or cut tubing re- placed, even if it is not leaking. 23.2 Gunite Slack Adjusters: Inspect the slack adjuster for any signs of damage. If dam- aged, have the slack adjuster replaced. Inspect the slack adjuster boot for cuts or tears. If the boot is damaged, have it re- placed. See Fig. 11.13 . 22.7 Check for kinked or twisted hoses. A seven-percent twist in the hose can re- duce its life by up to 90 percent. A twisted hose under pressure tends to untwist, which may loosen the fitting.

Reconnect hoses that are twisted. 4 5 6 NOTE: The front brake lines flex continu- ously in vehicle operation, so they require special examination. Give particular attention to the areas near where they connect to the front air brake chambers. This inspection requires two people, one in the driver seat and another to inspect the brake line con- nections at the wheels. 3 7 8 2 9 1 10 22.8 Both wheel air lines must be inspected with the emergency brake set, engine idling, air pressure at 80 to 90 psi (550 to 620 kPa), and the brake pedal held down. f421398 06/17/2003 1. 7/16-inch Adjusting Nut 2. Grease Fitting 3. Boot 4. Link 5. Brake Chamber Piston Rod 6. Clevis 7. 1/2-inch Clevis Pin 8.

1/4-inch Clevis Pin 9. Grease Relief Opening 10. Slack Adjuster Spline 22.9 Turn the wheels to full lock in one direc- tion and inspect both air lines where they connect to the air chambers, then turn the wheels to full lock in the other direction and inspect both lines. If a hose is leak- ing, have it replaced. Fig. 11.13, Gunite Automatic Slack Adjuster IMPORTANT: ABS-equipped vehicles operat- ing in regions where especially corrosive ice removal chemicals are used may experience higher than normal rotor corrosion. Tone rings should be routinely inspected for corro- sion.

Severe corrosion of the integral ABS tone ring may cause the ABS warning lamp in the dash to illuminate due to false wheel speed readings. If the ABS warning lamp illuminates at any time other than at vehicle start-up, have the problem repaired immedi- ately. 23.3 Haldex Slack Adjusters: Inspect each slack adjuster and anchor strap for dam- age. See Fig. 11.14 . Have any damaged components replaced. Check that the control-arm nut is fully re- leased. If the control arm is in the wrong position, the brakes will drag. 24. Check the air brake system for proper operation. 24.1 Check the air governor cut-in and cut-out pressures as follows. 23. Inspect the slack adjusters.

Run the engine at fast idle. The air gover- nor should cut out the air compressor at approximately 120 psi (827 kPa). With the engine idling, apply the brake pedal sev- eral times. The air governor should cut in the air compressor at approximately 100 psi (689 kPa). If the air governor does not 23.1 Meritor Slack Adjusters: Check the boot for cuts, tears, or other damage. Have it replaced if necessary. 11.12