Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance With the air system fully charged to 120 psi (827 kPa), stop the engine and note the air pressure. Then make one full brake application and observe the pressure drop. If it drops more than 25 psi (172 kPa), all areas of leakage must be elimi- nated before operating the vehicle. 1 2 3 24.4 Check the air leakage in the system as follows. With the parking brake (spring brake) ap- plied, the transmission out of gear, and the tires chocked, charge the air system until cut-out pressure of 120 psi (827 kPa) is reached. 4 8 9 7 6 With the service brakes released, shut down the engine, wait one minute and note the air pressure gauge reading.

Ob- serve the air pressure drop in psi (kPa) per minute. 5 10/11/2005 f421397 A. Rotate the control arm toward the brake chamber until you can feel it contacting the internal stop. 1. Clevis 2. Slack Adjuster 3. Clevis Pin 4. Manual Adjusting Nut 5. Control Arm A Charge the air system until cut-out pres- sure of 120 psi (827 kPa) is reached. With the parking brakes released and the ser- vice brake applied, shut down the engine, wait one minute and note the air pressure gauge reading. Observe the air pressure drop in psi (kPa) per minute. 6. Control-Arm Washers and Nut 7. Anchor Strap Slot 8. Anchor Strap 9. Brake Chamber Fig.

11.14, Haldex Automatic Slack Adjuster cut in and out as described above, it must be adjusted to these specifications. If the air governor cannot be adjusted or re- paired, replace it before operating the ve- hicle. If leakage exceeds the limits shown in Table 11.4 , repair all areas of leakage be- fore driving the vehicle. 24.2 Check the air pressure buildup time as follows.

Description Air Leakage in psi (kPa) Per Minute Released Applied Truck or Tractor Only 2 (14) 3 (21) Truck or Tractor w/Single Trailer 3 (21) 4 (28) Truck or Tractor w/Two Trailers 5 (35) 6 (42) Maximum Allowable Service Brake Air Leakage With the air system fully charged to 120 psi (827 kPa), make one full brake appli- cation and note the air pressure reading on the gauge. Continue to reduce the air pressure by moderate brake applications to a maximum of 90 psi (620 kPa), then run the engine at governed rpm.

If the time required to raise the air pressure to 120 psi (827 kPa) (from the pressure noted after one brake application) is more than 30 seconds, eliminate any leaks or replace the air compressor before operat- ing the vehicle. Table 11.4, Maximum Allowable Service Brake Air Leakage 25. Test the service brakes. When starting to move the vehicle and before picking up speed, test the brakes with the foot pedal and parking brake control valve (yellow knob) to be sure they will bring the vehicle to a safe stop. 24.3 Check the air pressure reserve as follows. 11.13