Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance adjustment for belt tension on engines with auto- matic belt tensioners. If there is not proper ten- sion, have the belt tensioner replaced. See Group 01 of the Heavy-Duty Trucks Service Manual for instructions, or take the vehicle to an authorized Freightliner dealer. 6.5 Check the web retractor for function and damage. 6.6 Check the mounting bolts for tightness and tighten any that are loose. Monthly Post-Trip Maintenance Procedures WARNING Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm.

To prevent possible per- sonal injury, always wash your hands after han- dling battery parts and related accessories. A B 10/31/94 f200036a A. Deflection B. Belt Free-Span 1. Clean the batteries. Fig. 11.16, Checking Belt Tension 1.1 Remove any corrosion from the hold-down and the top of the battery. 6. Inspect the seat belts and tether belts. CAUTION WARNING Inspect and maintain seat belts as instructed below. Worn or damaged seat belts could fail during a sudden stop or crash, possibly resulting in serious injury or death. Take care to keep the vent plugs tight so that the neutralizing solution does not enter any of the battery cells and damage the battery.

1.2 Use a soda solution to neutralize the acid present, then rinse off the soda solution with clean water. IMPORTANT: Seat belts have a finite life which may be much shorter than the life of the vehicle. Regular inspections and re- placement as needed are the only assur- ance of adequate seat belt security over the life of the vehicle. 1.3 If the battery posts or cable terminals are corroded, disconnect the terminals from the posts. Clean them with a soda solution and a wire brush. After cleaning, connect the terminals to the battery posts, then apply a thin coat of petroleum jelly to the posts and terminals to help retard corro- sion. NOTE:

When any part of a seat belt needs replacement, the entire seat belt must be replaced, both retractor and buckle side. 6.1 Check the web for fraying, cuts, or ex- treme wear, especially near the buckle latch plate and in the D-loop guide area. 2. Inspect the radiator and heater hoses, including the clamps and support brackets. 6.2 Check the web for extreme dirt or dust and for severe fading from exposure to sunlight. 2.1 Make sure the radiator inlet and outlet hoses are pliable and are not cracking or ballooning. Replace hoses that show signs of cracking, weakening, or ballooning. 6.3 Check the buckle and latch for operation and for wear or damage.

2.2 Make sure the heater hoses are pliable and are not cracking or ballooning. Re- place hoses that show signs of cracking, weakening, or ballooning. 6.4 Check the Komfort Latch for function and cracks or other damage. 11.15