Freightliner FLD Conventional — FLD Conventional

Pretrip and Post-Trip Inspections and Maintenance 2.3 Tighten hose clamps as necessary, but do not overtighten, as hose life can be ad- versely affected. Duty Trucks Service Manual for lining re- placement instructions and camshaft end- play inspection. 2.4 Be sure the hose support brackets are securely fastened. Make sure the hoses are not located near sources of wear, abrasion, or high heat. 4.3 Check the brake drums for wear and cracks. 4.4 Check that the inspection plugs in the dust shields or backing plates, if so equipped, are installed. IMPORTANT: Replace all hoses, including heater hoses, at the same time. Service-type knitted or braided yarn-reinforced neoprene hose is acceptable.

Silicone hoses having an extended service life can be substituted for the reinforced neoprene type. See the Freightliner Service Parts Catalog or contact your Freight- liner Dealer. 3. Check the steering wheel for excessive play. 3.1 With the front tires straight ahead, turn the steering wheel until motion is observed at the front wheels. 3.2 Align a reference mark on a ruler, then slowly turn the steering wheel in the oppo- site direction until motion is again detected at the wheels. 3.3 Measure the lash (free play) at the rim of the steering wheel. Excessive lash exists if steering wheel movement exceeds 2-1/4 inches (57 mm) with an 18-inch (450-mm) steering wheel.

If there is excessive lash, check the steer- ing system for wear or incorrect adjust- ment of the linkage and steering gear be- fore operating the vehicle. 4. Check the brake lining wear on all vehicles, in- cluding those with automatic slack adjusters. Proper brake operation is dependent on periodic maintenance and inspection of the brake linings. 4.1 Check that brake linings are free of oil and grease. 4.2 Inspect the thickness of the brake linings. If the axle assembly is equipped with a dust shield or backing plate, remove the inspection plugs.

If any brake linings are worn to less than approximately 1/4 inch (6.4 mm) at the thinnest point, have the linings replaced on all brake assemblies on that axle. See Group 42 of the Heavy- 11.16