In an Emergency Hazard Warning Lights Towing The hazard warning light tab is located on the turn signal control lever. See Fig. 13.1 . To operate the hazard lights, pull the tab out. All of the turn signal lights and both of the indicator lights on the control panel will flash. When it is necessary to tow the vehicle, make sure the instructions below are closely followed to prevent damage to the vehicle. WARNING Do not tow an unbraked vehicle if the combined weight of both vehicles is more than the sum of the gross axle weight ratings (GAWR) of the tow- ing vehicle. Otherwise brake capacity will be in- adequate, which could result in personal injury or death. Front Towing Hookup 1.
Disconnect the battery ground cables. CAUTION 02/02/95 f460312 Failure to remove the axle shafts when towing the vehicle with the rear wheels on the ground could result in damage to the transmission and other parts. Fig. 13.1, Hazard Warning Light Tab To cancel the hazard warning lights, push the turn signal control lever either up or down, then return the lever to its neutral position. 2. Remove both drive axle shafts. On dual drive axles, if the vehicle is to be lifted and towed, re- move only the rearmost drive axle shafts. Emergency Kit, Optional On vehicles equipped with an air fairing, remove both the forward and rearmost drive axle shafts if there is insufficient towing clearance.
An optional emergency kit package is located in the baggage compartment behind the driver’s seat if the vehicle has a sleeper compartment. If there is no sleeper compartment, the emergency kit is located behind and between the seats. The package includes one or more of each of the following: fire extin- guisher, first aid kit, and a triangular reflector and flare kit. 3. Cover the ends of the hubs with metal plates or plywood cut to fit the axle opening, and drilled to fit the axle shaft studs. This prevents lubricant from leaking out, and will keep contaminants from getting into and damaging the wheel bear- ings and axle lubricant.
If there is an emergency while driving, cautiously pull off the road, paying attention to other traffic. Turn on the hazard warning lights. Place the flares and reflec- tor along the side of the road, to alert other drivers that an emergency situation exists. CAUTION Failure to protect the frame rails from the chains could cause damage, leading to eventual frame failure. WARNING 4. On dual drive axles, if the vehicle is to be lifted and towed, chain the forward rear-axle assembly to the vehicle frame. Use protection to keep the chains from damaging the frame. Use extreme care when placing flares in emer- gency situations that involve exposure to flam- mable substances such as fuel.
An explosion or fire could occur causing serious personal injury. 13.1