Freightliner FLD Conventional — FLD Conventional

In an Emergency 5. Remove the bumper extension and chrome bumper, if so equipped. Remove the bumper fair- ing, if so equipped. 9. Lift the vehicle, and secure the safety chains. If extra towing clearance is needed, remove the front wheels. 6. On vehicles equipped with an air fairing, adjust the trim tab to the lowest position. 10. On vehicles equipped with an air fairing, repeat the measurement taken in step 8. The difference between the two measurements must not exceed 14 inches (36 cm). If necessary, lower the ve- hicle. CAUTION Do not pass a sling (for example, a rope or chain) from one tow hook to another to fasten for tow- ing (see Fig. 13.2 ).

Known as reeving, this prac- tice is not permissible in most industrial applica- tions of towing and hoisting. Reeving can overload the hooks and result in damage to the vehicle. WARNING Failure to lower the vehicle could result in the air fairing striking an overhead obstruction, such as a bridge or overpass, and causing vehicle dam- age or personal injury. 7. Attach the towing device. Due to the many vari- ables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator. 11. Connect the clearance lights, taillights, and sig- nal lights. Connect any special towing lights re- quired by local regulations. 8.

On vehicles equipped with an air fairing, mea- sure the distance from the ground to the bumper, or from the ground to a frame bracket. 12. Chock the disabled vehicle’s tires, and connect the towing vehicle’s air brake system to the ve- hicle being towed. Then, release the spring park- ing brakes and remove the chocks. OK 1 2 1 OK f880694 01/11/2006 IMPORTANT: Do not reeve when towing. 1. Tow Hook 2. Chain Fig. 13.2, Reeving 13.2