Freightliner FLD Conventional — FLD Conventional

In an Emergency WARNING Emergency Starting With Jumper Cables Failure to chock the tires or connect the tow truck’s air brake system before releasing the spring parking brakes could allow the disabled vehicle to suddenly roll. This could cause prop- erty damage or personal injury. When using jumper cables, follow the instructions below. WARNING Rear Towing Hookup Batteries release explosive gas. Do not smoke when working around batteries. Put out all flames and remove all sources of sparks or intense heat in the vicinity of the battery. Do not allow the ve- hicles to touch each other. Do not lean over the batteries when making connections, and keep all other persons away from the batteries.

Failure to follow these precautions could lead to severe personal injury as a result of an explosion or acid burns. CAUTION Using a rear towing hookup on a vehicle equipped with a roof fairing could cause damage to the cab structure. IMPORTANT: Because of the possibility of ex- cessive wind force which could cause damage to the cab, do not use a rear towing hookup on any vehicle equipped with a roof fairing. CAUTION 1. Place the front tires straight forward, and secure the steering wheel in this position. Make sure both starting systems have the same voltage outputs, and avoid making sparks. Other- wise the vehicle charging systems could be se- verely damaged.

Also, do not attempt to charge isolated, deep-cycle batteries with jumper cables. Follow the battery manufacturer’s instructions when charging deep-cycle batteries. 2. Disconnect the battery ground cables. CAUTION Failure to protect the frame rails from the chains could cause damage, leading to eventual frame failure. NOTE: On vehicles equipped with an optional jump-start post, attach the positive cable clamp to that post instead of to the battery. 3. On dual drive axles, using protection to keep the chains from damaging the vehicle frame, chain the forward-rear drive axle to the frame. 1. Apply the parking brakes and turn off the lights and all other electrical loads. 4.

Attach the towing device. Due to the many vari- ables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator. 2. Connect an end of one jumper cable to the posi- tive terminal of the booster battery (or jump-start post, if equipped), and connect the other end of the cable to the positive terminal of the dis- charged battery (or jump-start post, if equipped). See Fig. 13.3 . 5. Lift the vehicle, and secure the safety chains. If extra clearance is needed, remove the bumper extension, if equipped. 6. Connect the clearance lights, taillights, and sig- nal lights.

Also connect any special towing lights required by local regulations. WARNING Do the next step exactly as instructed and do not allow the clamps of one cable to touch the clamps of the other cable. Otherwise, a spark could occur near a battery, possibly resulting in severe personal injury from explosion and acid burns. 13.3