In an Emergency C 8. Disconnect the remaining cable from the newly charged battery (or jump-start post, if equipped) first; then disconnect the other end. A B D Fire in the Cab E + + The incidence of fire in heavy- and medium-duty trucks is rare, according to data from the National Highway Traffic Safety Administration. Federal Motor Vehicle Safety Standard #302 limits the flammability of specified materials used inside the cab, but de- spite this, most materials will burn. The cab of this vehicle contains urethane foam, which is of concern in this respect. + G + E + + F f540027b 10/18/94 1 2 A A. To Ground B. Connect 3rd C. To Frame (ground) D. Connect Last E. To Starter F. Connect 2nd G.
Connect 1st WARNING Urethane foam is flammable! Do not allow any flames, sparks, or other heat sources such as cigarettes or light bulbs to contact urethane foam. Urethane foam in contact with such heat sources could cause a serious, rapid fire, which could result in death, severe burns, or gas poi- soning, as well as damage to the vehicle. 1. Booster Battery 2. Discharged Battery Fig. 13.3, Jumper Connections 3. Connect one end of the second jumper cable to the negative terminal of the booster battery, and connect the other end of the cable to a ground at least 12 inches (300 mm) away from the batter- ies of the vehicle needing the start. The vehicle frame is usually a good ground.
Do not connect the cable to or near the discharged batteries. In Case of a Cab Fire As quickly as possible, bring the vehicle to a safe stop, apply the parking brake, turn off the ignition, and get out of the vehicle. 4. Start the engine of the vehicle with the booster batteries, and let the engine run a few minutes to charge the batteries of the other vehicle. 5. Attempt to start the engine of the vehicle with the batteries receiving the charge. Do not operate the starter longer than 30 seconds, and wait at least two minutes between starting attempts to allow the starter to cool. 6. When the engine starts, let it idle a few minutes.
WARNING Do the next step exactly as instructed and do not allow the clamps of one cable to touch the clamps of the other cable. Otherwise, a spark could occur near a battery, possibly resulting in severe personal injury from explosion and acid burns. 7. Disconnect the grounded cable from the frame or other nonbattery location; then disconnect the other end of the cable. 13.4