Freightliner FLD Conventional — FLD Conventional

Vehicle Access To open either vent window, push the vent window release lever button while pivoting the top of the re- lease lever 90 degrees forward. When the release lever clears the slide channel, push outward on the release lever. Glove Box The glove box ( Fig. 3.6 ) is located on the passen- ger’s side of the dash. To lock the glove box, insert the ignition key in the lockset, with the key teeth pointing to the left, then, without pushing in on the lockset, turn the key counterclockwise to vertical. Do not turn the key clockwise to the original position to remove it. To unlock the glove box, insert the key, and turn it clockwise to horizontal.

To open the glove box door, push the door latch button (lockset) at the top center of the door. When closing the vent window, hold the release lever in the forward-pivoted position, and pull it inward. When the outer edge of the lever clears the slide channel, pivot the top of the lever 90 degrees rear- ward. The button will automatically pop out to lock the vent window. Cab Door and Sleeper Compartment Vents To open any cab door vent ( Fig. 3.2 ) or sleeper com- partment vent ( Fig. 3.5 ), push the vent handle out- ward and to the right with your fingertips.

To close the vent, turn your hand so that your fingers are pull- ing on the handle from the front edge, then pull in and back on the handle. Use care to avoid pinching your fingers. 01/18/95 f600152a Fig. 3.6, Glove Box 1 Circuit Breaker/Relay Panel 2 The circuit breaker/relay panel (see Fig. 3.7 and Fig. 3.8 ) is located behind the dash skirt on the front wall of the cab. To gain access to the relay panel, turn the three access panel fasteners one-quarter turn, then remove the access panel. Cab-to-Sleeper Access WARNING Place rigid or heavy objects in storage areas on the floor or under the bunk. Sudden stops or swerves could cause personal injury if items fall from overhead storage shelves.

01/18/95 f720059a 1. Sleeper Compartment Vent 2. Handle-Access Cutout To open the sleeper access on vehicles with vinyl sleeper curtains, unzip the sleeper curtains. If de- sired, unsnap the curtains all the way around the sides and top, and remove the curtains. Fig. 3.5, Sleeper Door 3.3