Freightliner FLD Conventional — FLD Conventional

Heater and Air Conditioner perature control as needed to maintain the tem- perature. FRESH 1 OFF A/C HEAT/DEF MAX A/C DEF HEAT IMPORTANT: If equipped with a FRESH/ RECIRC push button ( Fig. 4.5 ), the system draws in fresh air when the mode control (upper lever) is at HEAT/DEF or DEF, regardless of the FRESH/RECIRC push button setting. However, when the mode control lever is at HEAT, and the push button is in, the system draws only recircu- lated air. To prevent the buildup of fumes or odors inside the cab (for example, from smok- ing), do not operate the heater and air condi- tioning system in a recirculation mode for more than 20 minutes. 2 3 RECIRC 4 10/08/98 f830070c Fig.

4.5, FRESH/RECIRC Push Button B 1 OFF 2 A/C HEAT/DEF MAX A/C VENT HEAT 3 02/06/95 f830071a A 4 C Air Conditioning A. Fan Switch at Position 4 B. Mode Control at DEF C. Temperature Control at WARM IMPORTANT: Operate the air conditioner at least five minutes each month, even during cool weather. This helps prevent drying and cracking of tubing seals, reducing refrigerant leaks in the system. Operate the air conditioner only after the engine compartment is warm, and the inte- rior of the cab is 70°F (21°C) or higher. During cold weather, the heater can be operated at the same time, to prevent discomfort. Fig. 4.6, Settings for Defog/Defrost B 1 OFF 2 A/C HEAT/DEF MAX A/C VENT DEF 4 3 1.

If the cab is hot inside, temporarily open the win- dows to let the hot air out. A C 2. Set the mode control to VENT and turn the fan switch off before starting the engine. 02/06/95 f830074a A. Fan Switch at Position 4 (or lower as desired) B. Mode Control at HEAT C. Temperature Control at WARM 3. Start the engine. 4. Move the mode control to A/C. See Fig. 4.8 . With the control at A/C, fresh air is drawn into the cab. With the control at MAX A/C, the air in- side the cab is recirculated. Fig. 4.7, Settings for Maximum Heat positions of the mode control, airflow is directed to the passenger’s door window. NOTE:

In mild weather the fan switch can be kept off, since forward motion of the vehicle will provide airflow through the heater. IMPORTANT: If the outside air is dusty or smoky, set the mode control at MAX A/C and keep the windows and vent closed, to prevent drawing in dust or smoke. On vehicles with the FRESH/RECIRC push button, recirculated air can be selected either with the push button in or by setting the mode control to MAX A/C. 4. If the vehicle has a sleeper with a rear climate control panel, set the controls as desired. For instructions, refer to "Heating, Auxiliary Heater and Air Conditioner." 5. Move the temperature control to COOL. In this position, no heat is given off by the heater.

5. When a comfortable temperature has been reached, adjust the fan switch setting and tem- 6. Turn the fan switch to the highest speed, 4. 4.3