Freightliner FLD Conventional — FLD Conventional

Heater and Air Conditioner B dashboard, but the center dashboard outlets are closed. 1 OFF 2 3 HEAT/DEF MAX A/C VENT DEF HEAT B A 4 1 OFF 2 A/C HEAT/DEF MAX A/C DEF HEAT 02/06/95 f830185a C 4 3 A. Fan Switch at Position 4 (or lower as desired) B. Mode Control at A/C C. Temperature Control at COOL A C 02/06/95 f830073a A. Fan Switch at Position OFF Through 4 as Desired B. Mode Control at VENT or HEAT C. Temperature Control at COOL Fig. 4.8, Settings for Cooling with A/C 7. As soon as cool air is flowing from the dash- board outlets, close the windows. Adjust the fan switch setting as desired. Fig. 4.9, Settings for Maximum Ventilation 2.

Set the temperature control to COOL for no heat- ing, or move it toward WARM for heat. 8. If the air from the vents is too cold, move the temperature control toward WARM to adjust the temperature. IMPORTANT: If equipped with a FRESH/ RECIRC push button ( Fig. 4.5 ), the system draws only recirculated air when the mode con- trol lever is at VENT or HEAT, and the push but- ton is in. To prevent the buildup of fumes or odors inside the cab (for example, from smok- ing), do not operate the heater or ventilation system in a recirculation mode for more than 20 minutes. 3. Set the fan switch at the desired speed. IMPORTANT: A FRESH/RECIRC push button ( Fig.

4.5 ) is standard equipment when there is no air conditioning. This control is an option when air conditioning is ordered. It allows the AC, VENT, and HEAT modes to be used with either fresh or recirculated air. When the mode control is at MAX A/C, the system draws only recirculated air, regardless of the FRESH/ RECIRC push button setting. When the mode control is at A/C and the FRESH/RECIRC con- trol is set for recirculation (push button in), the system functions the same as when the mode control is at MAX A/C.

To prevent the buildup of fumes or odors inside the cab (for example, from smoking), do not operate the heater and air conditioning system in a recirculation mode for more than 20 minutes. Heating, Sleeper Heater and Air Conditioner 1. If equipped with the manual temperature control, do the following ( Fig. 4.10 ): 1.1 With the engine at operating temperature, pull the temperature control cable (at- tached to the outlet duct at the foot of the bunk) all the way out. Turn the fan control knob to position 3. NOTE: The mode control must be at either A/C or MAX A/C, and the fan switch must be on for the air conditioning system to work.

Fresh Air 1.2 When the sleeper compartment heats to the desired temperature, push in the tem- perature control cable to adjust outlet air temperature. Then, turn the fan control knob to adjust the air flow level. 1. Move the mode control to VENT or HEAT. See Fig. 4.9 . In the VENT position, air comes out of the dashboard outlets but not out of the floor out- lets. In the HEAT position, air comes out of the floor outlets and the outlets on either end of the Use the manual temperature control and the fan control knob as needed to help maintain the desired temperature. 4.4