Freightliner FLD Conventional — FLD Conventional

Heater and Air Conditioner 1 1 01/18/95 f600516a 1. Fan Control Knob f600517a 01/18/95 2 1. Temperature Rheostat 2. Fan Control Knob Fig. 4.10, Control Panel for Manual Temperature Control System Fig. 4.11, Control Panel for Automatic Temperature Control System 1.3 Whenever heat is not desired, push the temperature control cable all the way in, and turn off the fan. Air Conditioning, Sleeper Heater and Air Conditioner 2. If equipped with either the Red Dot constant tem- perature control (CTC ) system, or the Behr au- tomatic temperature control system ( Fig. 4.11 ), do the following: 1. If equipped with the manual temperature control, do the following: 1.1 Turn on the cab air conditioner.

For in- structions, refer to "Air Conditioning." 2.1 With the engine at operating temperature, turn the rotary knob on the temperature rheostat all the way clockwise to HEAT. Turn the fan control knob to position 3. 1.2 Make sure that the temperature control cable (attached to the outlet duct at the foot of the bunk) is pushed in all the way. Turn the fan control knob to position 3. 2.2 When the sleeper compartment heats to the desired temperature, turn the rotary knob on the temperature rheostat counter- clockwise to adjust outlet air temperature. Then, turn the fan control knob to adjust the air flow level.

1.3 When the sleeper compartment cools to the desired temperature, turn the fan con- trol knob to adjust the air flow level. If needed, pull the temperature control cable out to adjust outlet air temperature. Use the temperature control cable and the fan control knob as needed to help maintain the desired temperature. The system will automatically maintain the selected outlet air temperature. 2.3 Whenever heat is not desired, turn the rotary knob on the temperature rheostat counterclockwise (as needed) and turn off the fan. 1.4 Whenever air conditioning is not desired, pull the temperature control cable out (as needed) and turn off the fan. NOTE:

Whenever the refrigerant compressor is operating, the fan will always run at a very 4.5