Seats and Seat Belts 01/18/95 f910072a f910074 05/30/2006 Fig. 5.14, Tether Belt Routing Fig. 5.16, Shortening the Tether Belt 2. Fasten the lap belt by pushing the link into the buckle until it latches. Give the belt a tug at the buckle. If the buckle unlatches, repeat this step. If the problem continues, replace the lap belt. 3. To unbuckle the lap belt, push the button on the buckle to release the seat belt link. NOTE: Make sure the lap belt is completely re- tracted when it is not in use. Three-Point Seat Belt With Komfort Latch WARNING Fig. 5.15, Lengthening the Tether Belt Wear three-point seat belts only as described below.
In case of an accident or sudden stop, in- juries could result from misuse. Three-point seat belts are designed to be worn by one person at a time. Seat Belt Operation Lap Belt WARNING 1. Before driving the vehicle, slowly pull the link end of the three-point seat belt out of the retractor and pull it across your lap (from outboard to in- board) far enough to engage the buckle. If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again. Wear lap belts only as described below. In case of an accident or sudden stop, injuries could re- sult from misuse. Lap belts are designed to be worn by one person at a time. 2.
Fasten the three-point seat belt by pushing the link into the buckle until it latches. See Fig. 5.17 . Give the belt a tug at the buckle. If the buckle unlatches, repeat this step. If the problem contin- ues, replace the three-point seat belt. 1. Before driving the vehicle, slowly pull the link end of the lap belt out of the retractor and pull it across your lap far enough to engage the buckle. If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again. 5.9