Seats and Seat Belts Armrest Angle Adjustment (Optional) America LLC urges that the driver and all passen- gers, regardless of age or physical condition, use seat belts when riding in the vehicle. Rotate the 9/16-inch bolt head on the back of each armrest clockwise to raise the armrest and counter- clockwise to lower the armrest. Seat belt assemblies in the vehicle meet Federal Motor Vehicle Safety Standard 209, "Type 1," and "Type 2" requirements. They are recommended for all persons weighing over 50 pounds (23 kg). Swivel Seat (Fig. 5.13) A swivel seat option is available for the passenger’s seat only.
A lever on the side of the seat base re- leases the swivel mechanism, allowing the seat to rotate on the base. A child restraint system should also be provided for each child weighing 50 pounds (23 kg) or less. It should meet the requirements of Federal Motor Ve- hicle Safety Standard 213, "Child Restraint Systems." When providing such a restraint system, carefully read and follow all instructions pertaining to installa- tion and usage for the child. Make certain the child remains in the restraint system at all times when the vehicle is in motion. In addition to seat belt assemblies, tether belts are installed on suspension-type seats.
Tether belts help secure the seat to the floor and are intended to re- strain the seat and seat belt in case of an accident or sudden stop. IMPORTANT: Seat belts have a finite life which may be much shorter than the life of the vehicle. Regular inspections and replacement as needed are the only assurance of adequate seat belt security over the life of the vehicle. See Chap- ter 11 for the inspection procedure. 1 Tether Belt Adjustment 04/16/96 f910143 1. Make sure the tether belt is attached to the cab deck and seat frame. Also, check that the belt webbing is correctly routed through the buckle, as shown in Fig. 5.14 . 1. Lever Fig. 5.13, Swivel Seat 2.
To lengthen the tether belt, turn the buckle at a right angle to the webbing, then pull the bottom webbing strap through the buckle until the de- sired length is reached. See Fig. 5.15 . WARNING Do not rotate the seat while the vehicle is in mo- tion. Doing so could increase the chance of per- sonal injury in the event of a crash. 3. Adjust the seat to the highest ride position. With no weight on the seat, tighten each tether belt by pulling the middle webbing strap away from the buckle to remove all slack. See Fig. 5.16 . Tether belts should not be so tight as to restrict move- ment of suspension seats. Be sure the straps are not twisted.
Seat Belts and Tether Belts General Information Seat belt assemblies are designed to secure persons in the vehicle to help lessen the chance of injury or the amount of injury resulting from accidents or sud- den stops. For this reason, Daimler Trucks North 5.8